| 13.10.1
|
Rat-tanged dirk (sword blade used as a dagger or spearhead), with long thin blade, pointed at both ends, with sloping shoulders. A rib runs nearly the full length of the piece (flattened in the last 2 cm of the blade end). The middle of the rib, near the attachment end, is thin, rhomboidal in section, narrowing to pointed tip or tang which is turned up slightly at the end. Approximately 1/4 down the length of the blade the flange broadens, so that two flat sides spread from the centre rib. The blade end of the dirk has nearly straight sides, but tapers gently to a rounded tip. Catling's type 1d; near Åstrom's type I4. As Catling suggests (1964, 56) the rat-tailed weapon, the most characteristic of prehistoric Cypriote metal forms, occurs in so many sizes that it is impossible to classify them as swords, dirks, daggers, or even spearheads.
|
|
| 13.10.12
|
Body almost cylindrical, pointed at bottom. Short neck, trefoil lip, handle that joins the shoulder an the lip.
|
|
| 13.10.37
|
Fragment of female (?), handmade head, with distinctive pointed nose.
|
|
| 13.10.38
|
Female (?) handmade head wearing a fillet. Pointed distintive nose.
|
|
| 13.10.6
|
Flat bronze heart-shape piece, flaring at the pointed end, with a spool-shaped element (reel-shaped, according to Catling, as recorded in the Ure archives), horizontally arranged and attached at the centre of the upper part; Each end of the spool comprises a flat disk, while at the centre the surface is curved and narrower, so that a vertical space is revealed between the heart and the spool.
|
|
| 2018.6.2
|
Long cylindrical bar pointed at one end and flattened at the other
|
|
| 23.11.31IIII
|
Female facing left, wearing a pointed headdress over long styled hair. One hand appears to be held up to the face. There is a thin spike projecting upwards at the back. The skirt is belted at the waist, and is patterned with vertical bands containing zigzags or chevrons which terminate at a shin-length curved hem. The left shin and foot appear angled back to the other foot, giving the figure the appearance of walking.
|
|
| 34.10.12
|
Top closed, perforated with two concentric rings of holes (six inner, nine outer) around pointed knob.
|
|
| 34.2.2
|
Small hydria with plain everted rim, with a round lip, curving continuously to a narrow concave neck and a sloping shoulder, then an ovoid body attached to a short disk foot, tapering on both exterior and interior, with a flat resting surface and a pointed underside. The vertical strap handle, slightly concave on its outer side, reaches from the lip to the widest part of the body, where it curves into the shoulder. Two horizontal d-shaped, upcurving handles, round in section, also rise up from the join of the shoulder and body.
|
|
| 39.1.2
|
Strongly moulded rim, curving into a roughly cylindrical upper body that bulges out into the shallow bowl. Two vertical handles, roughly square in section, with horizontal pointed spurs, level with the rim, rejoin the body at the upper part of the bowl. Two-part moulded foot, with a domed underside.
|
|
| 47.10.3A-B
|
Lid: tall, conical, flat-topped knob on a sharply sloping conical lid, with plain rim, vertical profile, flat underside, leading to a short flange (0.3) to sit within lekanis.
Lekanis: slightly everted, rounded rim with flat lip, on a deep bowl with straight walls in two parts, separated by a sharp carination near the bottom, attached to a short disk foot, angled on inside and out, with a slightly convex underside. From either side of the rim extends a semicircular horizontal handle, round in section, that rises very slightly, flanked by short pointed spurs or lugs on either side of the handle.
|
|
| 47.2.27
|
Cylindrical figure of a warrior. Pointed helmet, moulded face with long beard. Arms across chest, right carries shield, may have also held a spear, although now damaged.
|
|
| 47.2.32
|
Standing, mouldmade figurine, playing tambourine with slightly round back. Cylindrincal filled body, pointed headdress and moulded arms, placed across body.
|
|
| 47.2.33
|
Standing, mouldmade female, holding tamborine and wearing pointed cap. Ears and nose most prominent facial features, with virtually no mouth visible, fingers incised.
|
|
| 47.2.34
|
Standing mouldmade female, holding tambourine, with pointed headdress and large hands.
|
|
| 50.12.51
|
Fragment almost cylindrical, but pointed at both ends.
|
|
| 51.7.3
|
Flaring lip with rounded rim, sharply joined to ovoid body; single round, curved vertical handle rises up from alongside the lip and rejoins at the shoulder; lower part of body sharply joins to a short, flaring foot, concave on the underside, with a pointed underside.
|
|
| 56.8.2
|
Tall inslanting rim with plain round lip, sharply turning to a short shoulder that broadens to an ovoid body, which tapers to a tall moulded foot, comprised of a beveled top, two concave elements, a carination, below which a scotia above a torus. The resting surface is ridged and the underside consists of a pointed convex centre, within a tapering concave part. Two u-shaped handles, round in section, rise from the bottom of the shoulder to high above the rim. On either side of each handle is a pointed lug.
|
|
| 58.2.5
|
Round body somewhat pointed at the base. Cut-away neck spout (derived from Anatolian precursors). Handle attaches to the middle of the spout and then rejoins the jug on the shoulder.
|
|
| 59.6.3
|
Single but ornate handle that has pointed oval at bottom, two moulded lines towards top and a piece that curves up separate to the main handle in a 'cobra-like' strike pose. The main piece of the handle extends along rim of vessel in a leaf-like shape with notches in the edges. Mouth is wide and has small rim. Outside body is marked with 4 pairs of incised bands around its sides. Small curve at side of foot. Base is flat but has 6 incised concentric circles and a central sunken dot.
|
|
| 60.8.3A-B
|
Lid: three tiered round knob with central, nearly conical well; short concave stem curving above and below into knob and lid; nearly flat lid tapering gently to a short vertical rim, rounded at both edges. The underside is slightly hollowed under the knob. Lekanis: shallow bowl with a short nearly vertical flange, rounded at the lip, straight but tapering walls, slightly carinated and narrowing, with convex lower portion, to a very short stem, on a rounded disk foot, with a flat resting surface, curved on the underside, with a rounded point at the centre. A wishbone handle rises from the top of the wall, on either side; a lug protrudes from either side of each handle.
Ure 1960, 216 notes that what remains of the one handle indicates that it was pointed (wish-bone shaped) at the centre as well as rounded in section.
|
|
| 71.12.4
|
Ornamental fibula (pin). Long straight pin with pointed end attached to semi-circular piece that thickens and flattens at the end. There is no hinge here but a curled piece joining the pin and the semi-circle acts as a hinge.
|
|
| 83.2.4
|
Horn shaped fragment, with smooth outside. Pointed one end and moderately flat on the other.
|
|
| 83.2.5
|
Horn shaped fragment, with smooth outside. Pointed one end and moderately flat on the other.
|
|
| E.2002.8.1
|
Pronounced thick lip, no neck, bulbous body tapering to a pointed base.
|
|
| E.2003.9.1
|
Wide-mouthed jar, with a pointed base
|
|
| E.23.19
|
Tall pointed jar with flattened, narrow base. Wide mouth with narrow lip and wide neck. Lugs at either side, perforated with thread holes.
|
|
| E.23.23
|
Pear shaped jar with a pronounced lip, short neck, and pointed base, widest point has a ridge which is uneven.
|
|
| E.23.28
|
Everted lip, carinated body, and pointed foot.
|
|
| E.23.32
|
Undulating lip, long neck, bulbous shoulder tapering to a pointed base. Two opposing handles emerge on the sholder just below the band decoration.
|
|
| E.23.33
|
Lip is unpronounced, long neck flares to shoulder/widest point, which then tapers to pointed foot. The rough handles are directly opposite each other on the widest point.
|
|
| E.62.46
|
Flat and thin blade with a nail through to both sides, perhaps for attaching a wooden handle. The blade is pointed at one end then widens in a triangle then thins again but not to a point.
|
|
| E.63.10
|
Miniature papyrus sceptre worn as a pendant (suspension hole at top). Zig zags taper to the main body the top of which is decorated with four incised lines. The body swells and then tapers to a pointed base.
|
|
| E.63.23
|
Thin lip, narrow neck, curved shoulders and pointed base.
|
|
| E.63.26
|
Pointed
|
|
| E.65.1
|
Wide flaring lip with rounded rim, narrowing to a short neck, broadening to an ovoid body, with a pointed base.
|
|
| E.65.7
|
Pointed base flattened; small mouth; lugs at either side, perforated to take thread.
|
|
| L.2016.3.13
|
Bronze figurine of a dog or cow, with geometric body shape: Elongated back/belly, pin-like legs (standing wide apart), short pointy muzzle, slightly outwards pointed ears or horns, downwards sloping tail.
|
|
| REDMG:1934.26.1
|
Small cup with rounded rim on a flaring lip that sharply joins a shallow bowl with bulging profile; two horizontal round handles, canted up, join at the broadest part of the bowl. The bowl has almost no stem but attaches directly to a raised ring base with diagonal profile, slightly convex resting surface, and slightly pointed underside.
|
|
| REDMG:1934.51.8
|
Nearly conical shallow bowl, with a slightly incurving rounded rim, slightly convex side walls, and a thick, small foot, with straight sides on the exterior, tapered on the interior; pointed underside.
For shape cf. CVA France 6 (Ensenere) pl. 22 and Lamboglia (Atti di I congr. Intrem di Studi Liguri (1950) 39, forma 26.
|
|
| REDMG:1935.87.15
|
Plain rim with flat lip, just below which is attached a horseshoe shaped horizontal handle, slightly canted and rising to just above the rim;.flattened hemispherical body attached to a ring foot, rounded on the outer surface, with a flat resting surface, and curved interior wall, offset from pointed underside.
|
|
| REDMG:1935.87.6
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards, to which spurs are attached on either side. The lower body is offset from the handle zone, rounded in the lower part where it sharply joins a moulded foot, with groove above a spreading upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface, and a pointed, slightly offset underside.
|
|
| REDMG:1951.134.1
|
Plain rounded rim, body nearly vertical at top and curving into a deep bowl, which narrows to a short stem attached to a disk foot with a rounded resting surface, small underside pointed at centre. Two horseshoe-shaped horizontal round handles, attached slightly below the rim.
|
|
| REDMG:1951.141
|
Flaring rounded rim with flat lip, narrowing to a funnel-shaped body that curves sharply in the lower part to a broad stem that flares into a molded pedestal base, with a slanted exterior, ridged on the upper part, and a concave underside, pointed at the centre; two incurving horizontal round handles are attached just above the centre of the body.
|
|
| REDMG:1951.144.1
|
Central well, surrounded by a ridge, rising to broad rim with overhanging vertical lip, tapering slightly in; on the underside the plate curves to a short, thick stem that broadens to a moulded foot, concave and flaring on the exterior surface, hollowed on the interior, with a flat resting surface, pointed at centre of plate.
|
|
| REDMG:1951.152
|
Moulded grooved rim, with a flat overhanging lip, atop a thin, nearly cylindrical neck, attached to an ovoid body, ridged at the top; raised base, with thin reseting surface and slightly pointed underside.
|
|
| REDMG:1953.25.16
|
Trefoil mouth at the back of which is attached a hook-shaped round handle that begins above the height of the mouth and turns back to join the shoulder, with a slight spur; short neck curving into a baggy body in a continuous curve; short ring foot with narrow, rounded resting surface, diagonal inside wall, and pointed underside. Handle attachment is indicative of the Dotted Spray Group
|
|
| REDMG:1953.25.33
|
Central well, surrounded by a ridge and groove; walls rising to broad rim, just beyond a groove on the upper surface, with overhanging vertical lip, tapering slightly out; on the underside the plate is slightly convex and joins a short, thick, angled ring foot, with a tapering resting surface and a slightly convex, pointed underside.
|
|
| REDMG:1953.25.35
|
Chimney mouth, bell-shaped, flaring at the top, with a broad rim, convex on the upper surface, and sloping in; the mouth is offset from a short neck that broadens toward the barrel-shaped body, from which it is also offset; thick disk foot, rounded in profile, with a thin resting surface, concave on the underside, pointed at centre; strap handle (missing) rose from the side of the neck and rejoined at the lowest part of the shoulder.
|
|
| REDMG:1964.1631
|
Very thin walls, with rounded rim, just below which are attached horizontal handles. Walls slightly concave, divided from a spreading, lipped torus ring foot, with a pointed resting surface, by a pair of grooves. This example corresponds to Ure's Class II.C skyphos, particularly (ii) which includes reddish-purple bands just below the level of the handles, perhaps a band at the bottom of the body where it joins the ring foot, and concentric purple bands on the underside (or plain black or reserved undersides). See Ure 1927, 24.
|
|
| TEMP.2003.6.3
|
(a) Part of a triple handle and part of the area of the body where it was joined. (b) Part of lower body area and ring-shaped base with a concave area, whose central, inflated part is pointed.
|
|