| 13.10.4A-B
|
Two slightly concave disks, not joined (although they sit together well). The lid is thinner than the base with no significant rim, but a beveled edge. The mirror itself has a rim on the underside, and an offset edge on the upper part. These are clearly two parts of a Hellenistic mirror with lid, typical of Hellenistic cyprus. A pair of bronze plates could be locked together because one mirror had a low cylindrical rim into which the other, with a flanged edge, could be fitted. The inside mirror is decorated on the recessed side and polished on the flat side. The outside mirror is polished on the recessed side and sometimes decorated on the flat side. The two polished sides would then lie together, sometimes plated with silver (as in the case of an example in Amathus tomb 62, published in Excavations in Cyprus). For the Greek prototypes see See A. Schwarzmaier, Griechische Klappspiegel: Untersuchungen zu Typologie und Stil (Berlin 1997).
|
|
| 2005.2.5
|
Rectangular prism, taller than wide, pierced through the upper part, ca. 1 cm. from the top.
|
|
| 2007.10.2.110
|
Squashed oval - the left side is far less curved than the right.
|
|
| 2007.9.11
|
Four-sided, large curved ridge on outer surface, fragment depth much deeper at two edges than at remaining two.
|
|
| 2007.9.12
|
Three sided, one side considerably shorter than other two.
|
|
| 25.9.3
|
The rim is wide and sloping, the handle is double, of ellipsoid cross-section and forms an intense curve against the body, which is ovaloid and inflated. The base is ring-shaped and narrower than the rest of the vessel.
|
|
| 35.4.4
|
Trefoil lip oinochoe, with a handle of ellipsoid cross-section that is raised higher than the lip. The body is spherical and the short foot is conical. Gill's shape 5c.
|
|
| 39.9.7
|
The body is supported by a low-stemmed, ring-shaped base, gradually widening out to the foot. The handles are handmade, almost circular and they rise a bit higher than the rim.
|
|
| 47.2.10
|
Rounded, thickened, out turned rim, broader than base; convex wall descending directly to a flat base, grooved on the underside.
|
|
| 47.2.29
|
Female tambourine player, with wheelmade body, moulded face and handmade arms. Facial features well preserved. Right hand plays tambourine and is placed higher than left.
|
|
| 48.12.2
|
Deep bowl (corresponds to FS [='Furumark Shape'] 285). The shape seems somewhat less deep than most published deep bowls. The best comparison to be found is in Mountjoy 1999, 1.189 Argolid no. 447, from Asine, House I, room 46. Bowl of pinkish fabric with flaring lipless rim, concave sides, tapering in lower part to a high ring base (is it conical?). Two horizontal round handles are attached to the side walls.
|
|
| 50.4.13
|
Attic type skyphos (cf. Agora 12, no. 341) except for plain underside, size (somewhat smaller than Attic examples), and perhaps breadth of handles. Rounded rim, below which are two horizontal round handles, horseshoe shaped. Walls continuously curve into a deep bowl, divided from the short torus ring foot by a groove.
|
|
| 51.7.1
|
Trefoil lipped; high handle with ridge down middle curves up from the shoulder considerably higher than the rim; neck progresses smoothly to body, as body does to foot; foot is stepped with the side reserved; underneath is ruddled and concave with convex centre.
|
|
| 58.2.6
|
One-handled bowl. Rim is slightly concave. Handle is in wishbone shape. A deep well is in the centre, of a greatly smaller diameter than the rest of the bowl. For general shape cf. Sydney, Nicholson Museum 55.18 (Base-ring wheel-made Ware, Late Cypriot III).
|
|
| 64.7.1
|
Stemless (of a late type). Thin inturned rim; shallow bowl; one remaining rounded handle curves up slightly higher than the rim from just below the rim; round footring; flat underside with slight moulded circle on base.
|
|
| 67.7.2
|
Outturned rim; long, thin, roughly rendered neck; inverted oviod body tapering smoothly into thin stem slightly shorter than neck; flares out to flat base.
|
|
| 70.3.1
|
Cf. "Sixth and Fifth Century Pottery", P.N.Ure (ed.), p51 shape class M (see also 'Comments') - although lip is slightly more protrusive than the type indicates as its norm.
|
|
| 70.3.3
|
Ian McPhee describes it as a Kotyle rather than Skyphos type c (?). Tapering ring base, rounded at the bottom, from which the body rises in a sharp diagonal, curving sharply approximately at the halfway point, from which it rises near vertically and eventually flares slightly to a plain, rounded rim, just below which are attached two horse-shoe shaped handles, almost round in cross section.
|
|
| 71.12.6
|
Wide strigil curved in a tight arc. Handle is square and thinner on the back than the front as it bends over to make an oblong shape. The handle adjoins the strigil in a long triangular point with an incised line acting as a border.
|
|
| 73.6.5
|
Rectangular pot fragment with one side being more curved in shape, and the other consisting more of a straight line. One end is longer than the other owing to the curved side making it so.
|
|
| 78.12.4
|
Shallow circular body (back deeper than the front), small convex shoulder, concave discus with a very small filling hole in the centre. Nozzle is flat with concave sides , a rounded tip and a circular wick hole that is just off centre. Base is demarcated and slightly concave.
|
|
| 78.12.7
|
Shallow circular body, small shoulder with concave discus with a small filling hole just off the centre of the discus. Medium nozzle, flat with concave sides, rounded tip and central circular wick hole. Base is unmarked, circular and slightly concave. Right hand stands slightly taller than the left.
|
|
| 79.1.16
|
Mainly circular body, nozzle is moulded with body disturbing the circular edge back half of body is deeper than the front. Shoulders are convex, discus is concave with a small circular filling hole in the centre. Long deep nozzle, sides follow smoothly on from the body, elongating the circular shape, slightly concave top marked with a ridge on either side, rounded tip and slightly irregular circular wick hole. Remains of small vertical handle attached to the shoulder. Small circular base, slightly concave not lineated.
|
|
| E.23.41.1-25
|
Beaded necklace, not on original string, consisting of 25 beads. All are circular but some are broader, bigger, rounder than others. Two small beads, one on each end which string is tied too.
|
|
| E.62.48
|
The fragment is wider at the top than the bottom and there is a cylindrical hole that goes right through the object.
|
|
| REDMG:1935.87.23
|
Two handles, all black and one either side which start at base of body and curl up and over, higher than mouth with small spurs at the base. Mouth has wide rim.
|
|
| REDMG:1951.113.3
|
Rounded rim, slightly incurving, below which are attached two nearly triangular horizontal strap handles and ring base, canted slightly up; rounded body broadens slightly and then narrows to an angled ring foot, curved on the resting surface, and offset from the slightly convex underside. Body broader than standard Apulian shape, so that it can't fit easily into the sequence of Gnathian skyphoi.
|
|
| REDMG:1951.145
|
Cylindrical lid with inset flat top and raised edge, stepping down in three ridges, broader than the width of the walls; slightly tapering walls terminating in offset flanged rim.
|
|
| REDMG:1953.25.2
|
Rounded, slightly everted rim, below which are attached two horizontal handles, rounded on the outsides and slightly flattened on the insides, slightly canted and rising above the rim. Body bulges slightly below handles but otherwise tapers gradually to a thick raised base, which is slightly broader than the lowest part of the body. The underside is circumscribed with a lightly gouged band.
|
|
| REDMG:1964.1603.1
|
Circular deep body with lower body wider than the upper. Flat , slightly concave rim to a large circular filling hole. nozzle is long and flat with small oval wick hole at the tip and a small depression at the end of the tip. Base is flat and circular, wheel or wire marks still exist on the base. Band handle is attached across the back of the lamp.
|
|
| REDMG:1964.1612.1
|
Main body; circular with long nozzle, low girth, rim of large circular filling hole is stepped down from the shoulder. Nozzle is smooth and cylindrical with one side deeper than the other. Large circular, high vertical handle attached to the shoulder opposite the nozzle. Small slightly of centre foot is circular and has a concave base. Kick on the interior of the base.
|
|
| REDMG:1964.1621
|
Wide mouth with moulded, slightly concave lip, and slightly everted rim, below which the short vertical strap handle emerges, bends, and descends to the shoulder. Globular body attached to an angled ring foot. Shape similar to Corinthian round-mouthed oinochoe, type B (cf. Corinth 13, fig. 14), but with a slightly concave lip, and more globular than Corinth T1712: Corinth 13, 228 no. 296-2, pl. 41.
|
|
| TEMP.2003.6.12
|
The handle is riddled, of ellipsoid cross-section, curving upwards, higher than the rim.
|
|
| TEMP.2003.6.6
|
Two-handled skyphos. The double, riddled handle is of ellipsoid cross-section and curves upwards (higher than the body).
|
|
| TEMP.2003.6.7
|
Two-handled skyphos. The handles are of ellipsoid cross-section, riddled and curving upwards (higher than the body). a) Part of the rim and body. c) Part of the body. d) One handle and part of the body. e) Part of the other handle. f) Tiny bit of the handle. g) Part of the handle and body.
|
|
| TEMP.2022.6.2
|
course jug with fat body, thick rim. The single handle reaches from the neck beneath the rim to the shoulder of the jug. The neck beneath the rim to the shoulder of the jug. The neck is as wide as the mouth, protunding edge; the base is smaller than the body and it is flat.
|
|
| temp.2022.6.2
|
Apulian/ Messapian ceramic jug, course jug with fat body, thick rim. The single handle reaches from the neck beneath the rim to the shoulder of the jug. The neck is as wide as the mouth; protunding rim; base is smaller than the body and it is flat
|
|
| temp.2022.7.5
|
amphora with rounded body, wider in the upper part; flat base, two symmetrical handles, the neck is smaller than the body and is partially broken; there is a groove between the neck and the body
|
|