| 2008.7.54
|
Hexagonal fragment from possibly neck of a pot as the exterior top of the fragment curves out into what could be a lip; exterior base of fragment also begins to curve outwards; horizontal curvature to the fragment
|
|
| 23.11.31V
|
Warrior facing right, with crested helmet and round shield decorated with "bicycle-spoke" design. There is an also area of square grid-marking on the neck, below the back of the helmet.
|
|
| 29.11.2
|
Cup mouth. The top of the rim slightly curving upwards. Cylindrical neck. Strap single handle connecting the beginning of the neck with the shoulder. Shoulder curves slightly down to straight body. Broad torus ring foot. Underside flat except conical center.
Cf. Smith 2003, BSA 98, p.360, footnote 26, pl. 59 a-b (see also 'Comments').
|
|
| 30.11.1
|
Also called bombylios.
|
|
| 34.2.2
|
Small hydria with plain everted rim, with a round lip, curving continuously to a narrow concave neck and a sloping shoulder, then an ovoid body attached to a short disk foot, tapering on both exterior and interior, with a flat resting surface and a pointed underside. The vertical strap handle, slightly concave on its outer side, reaches from the lip to the widest part of the body, where it curves into the shoulder. Two horizontal d-shaped, upcurving handles, round in section, also rise up from the join of the shoulder and body.
|
|
| 45.6.30
|
Molded, overhanging rim with a lower flange, curving into a thin neck which gradually widens to an ovoid body; molded foot, concave on the underside.
For shape cf. bottles found at Metaponto that are similar (in shape and decoration) catalogued by L. Burn in Carter 1998, 2.632-633, especially T 192-6. Cf. also Padova, Museo Civico Archeologico inv. 1746-C: Zampieri 1996, 203-204 no. 58 (ill.).
|
|
| 47.2.27
|
Cylindrical figure of a warrior. Pointed helmet, moulded face with long beard. Arms across chest, right carries shield, may have also held a spear, although now damaged.
|
|
| 48.11.8
|
This shape was particularly popular at Agrigento, where many tombs contained one example (it is called 'brochetto attingitoio' or juglet for drawing liquids, comparable to the attic 'chous'): see especially Veder Greco, Contrada Mosè: 264 (tomb 3); Contrada Pezzino: 306 (tomb 582), 348 (tomb 238), 352 (tomb 779), 353 (tomb 1086), 354 (tombs 585 and 1147), and 355 (tomb 1225). Cf. also Lentini 61613/E (top half glossed) and 61569/B (smaller): Lagona 1973, 86-87 nos. 185 and 186, pl. 30.
|
|
| 48.12.10
|
Long tall neck from the top of which handle loops up and then down to join edge of broad shoulder, curning slightly upwards. Straight body; sturdy, flat foot; concave base.
Cf. Smith 2003, BSA 98, p349, footnote 24, pl. 58 d-f (see also 'comments').
|
|
| 50.4.19
|
The shape is nearly identical to that of a smaller lekythos from the Pantanello Necropolis at Metaponto, published by M. Elliott in Carter 1998, 2.684-85 SL10 (T 128-3), although the ribbing is more akin to that found on Pantanello SL9 (T 126-9). Cf. also Sicilian examples from Agrigento (especially AG 1331: de Miro 1962, 137, fig. 41c). See also 'comments' below.
|
|
| 50.4.23
|
Circular deep body with a small convex shoulder. Discus is concave with a small filing hole off centre and a small protruding nodule also off centre; this is probably the remains of a suspension lug. Long flat nozzle with a rounded tip and a large wick hole off centre at the end. Base is flat and demarcated with a line.
|
|
| 51.4.11
|
Moulded rim, grooved, with flat upper surface and sharp lip, on a short cylindrical neck, with attaches, at a ridge, to an ovoid body, attached below, also at a ridge, to a slightly flaring stand, with splaying foot, slightly ridged on upper edge, bevelled on exterior, hollow on the interior. From the shoulder, on either side, rises an m-shaped handle (half of one chipped off) with short projections in the middle. Three holes (to enable air flow) are drilled into the upper part of the stand, just below the join.
|
|
| 61.6.1.4
|
Very uneven in shape. Surface left very rough. The lip is uneven, leading into a very open interior which is widest at the mouth. The body is rough, while the base is also roughly made with no smooth finish to the edges.
|
|
| 65.6.1
|
The mouth is conical, the handle is of ellipsoid cross-section and the foot is disk-shaped.
Cf. 'The Red and the Black: Studies in Greek pottery' by B. A. Sparks, 1996, p20 fig I:12 (see also 'Comments' field).
|
|
| 70.3.1
|
Cf. "Sixth and Fifth Century Pottery", P.N.Ure (ed.), p51 shape class M (see also 'Comments') - although lip is slightly more protrusive than the type indicates as its norm.
|
|
| 77.5.1.1-17
|
Seventeen fragments from the same Nikosthenic amphora. 1) Should be rejoined to 2. Part of the body. There is white plaster on both surfaces . 2) Should be rejoined to 1. Part of the body. There are traces of plaster on both sides and adhesives. 3) Part of the body. White plaster and adhesives on both sides. 4) Part of the body. White plaster on both sides and adhesives. 5) Should be rejoined to 6. Part of the body. Adhesives. 6) Should be rejoined to 5. Part of the body. Exterior: There are areas that have been chipped off and few bits that have been pitted off. Interior: There is a layer of white plaster. 7) Could be rejoined to 8? Part of the body. There are bits that have been pitted off on the exterior and the interior is covered with plaster and adhesives. 8) Could be rejoined to 7? Part of the body. White plaster and adhesives on the interior and traces of plaster on the exterior, where there are also bits that have been pitted off. 9) Should be rejoined to 10. Part of the body. White plaster on both surfaces. 10) Should be rejoined to 9. Part of the body. The interior is covered with white plaster and there are traces of it on the exterior. 11) Should be rejoined to 12. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 12) Should be rejoined to 11. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 13) Should be rejoined to 14. Part of the neck. There are traces of white plaster on the interior. Many bits have been pitted off from boith surfaces. 14) Should be rejoined to 13 and 15. Part of the neck. There are traces of plaster and adhesives on both sides, as well as many bits that have been pitted off. 15) Should be rejoined to 14. Part of the neck. There are traces of white plaster on both surfaces, as well as adhesives. There are few scratches on the exterior and several bits that have been pitted off, especially from the interior. 16) Part of the body. Adhesives and traces of white plaster. There are areas on the exterior, where the colour appears to have been peeled off and some pitting off. 17) Bit of white plaster-part of rim? and covered with adhesives.
|
|
| 79.1.14
|
large circular shape with a short rounded nozzle. Three bisected un-pierced lugs placed on the shoulder of the lamp equidistantly. The discus is sunken and there is a moulded rim to the discus which runs all the way around the wick hole in a continuous form. The wick hole and the filling hole are the same size and are in line with each other, there is also what appears to be an air hole in-between the channel of moulding. There is a ring base.
|
|
| 79.1.5
|
Circular body with convex shoulder and a concave discus with small filling hole. Small raised protruding foot with flat base. Large vertical handle with one incised line along the length of it and a second band laying across the handle at the highest point, also with an incision along it. Long spout with irregular splayed tip, large oval wick hole. joining lines of the handle and the nozzle are apparent.
|
|
| 83.9.12
|
'Delicate class': for the same shape cf. also Reading 14.9.113 (from Gela?) and 83.9.12 (also from Al Mina).
|
|
| E.62.17
|
Stone scarab. The beetle is sat on a flat base. The upper body is flat. The antenna and 'head' of the beetle are also detailed.
|
|
| E.62.40
|
Three pieces. Lid is circular and flat with a central knob handle, also circular. Second piece is the ring which sits between lid and base and is circular with a central hole cut out and a rim on the underside so it sits in the base. Base is wide at shoulder and tapers to the bottom with smooth walls. At top is a slighlty raised rim to receive ring. Inside is a hollowed out cylinder, not to the contours of the outer wall.
|
|
| REDMG:1935.87.32
|
Column krater. The handles have two bars of a cylindrical cross-section and adjoin in a square at the rim, having side-surfaces above the bars. The foot is in the shape of an inverted echinus, a cylindrical stand widening towards the bottom. There is also a plastic ring just below the lowest part of the body.
|
|
| REDMG:1951.140.1
|
Broad rim, slightly convex on upper surface, ridged at the outside edge, with overhanging lip; neck, concave in profile, broadens to a nearly flat shoulder that curves sharply to an ovoid body, which narrows sharply at the bottom, where it is joined to a moulded pedestal foot with a splayed base and concave underside; upper part of foot has tapering straight sides; the profile of the base is decorated with two ridges. Two incurving horizontal handles, round in sectiona, are attached to the upper third of the body; a vertical handle, also round in section, emerges from the top of the neck and curves down to the lower part of the shoulder.
|
|
| REDMG:1953.25.35
|
Chimney mouth, bell-shaped, flaring at the top, with a broad rim, convex on the upper surface, and sloping in; the mouth is offset from a short neck that broadens toward the barrel-shaped body, from which it is also offset; thick disk foot, rounded in profile, with a thin resting surface, concave on the underside, pointed at centre; strap handle (missing) rose from the side of the neck and rejoined at the lowest part of the shoulder.
|
|
| REDMG:1953.25.53
|
Incurving rim with concave lip, narrowing to a short neck at the top of which is attached a small vertical strap handle that extends the the shoulder; wall curves continuously from neck, widening to an ovoid body atop a disk foot; underside concave with a slight circular protruberance at centre. Tapering 'cucumber', survival of the Late Corinthian Archaic type (see Corinth 13, 140-41, fig. 15), but with a disk foot. E.g. Corinth T1317: Corinth 13, 222 no. 277-4, pl. 37. Cf. also Rhitsona 50.273.
|
|