| 13.10.4A-B
|
Two slightly concave disks, not joined (although they sit together well). The lid is thinner than the base with no significant rim, but a beveled edge. The mirror itself has a rim on the underside, and an offset edge on the upper part. These are clearly two parts of a Hellenistic mirror with lid, typical of Hellenistic cyprus. A pair of bronze plates could be locked together because one mirror had a low cylindrical rim into which the other, with a flanged edge, could be fitted. The inside mirror is decorated on the recessed side and polished on the flat side. The outside mirror is polished on the recessed side and sometimes decorated on the flat side. The two polished sides would then lie together, sometimes plated with silver (as in the case of an example in Amathus tomb 62, published in Excavations in Cyprus). For the Greek prototypes see See A. Schwarzmaier, Griechische Klappspiegel: Untersuchungen zu Typologie und Stil (Berlin 1997).
|
|
| 27.4.5
|
Rim turns sharply out, broad and flat on top. Handles rounded at far end and with upward twist. In centre of bowl a well 1.5 cm deep occupies the space interior of the stem. The foot appears in three stages, the first ridge being the narrowest, and the other two getting bigger in sequence.
|
|
| 34.2.1
|
Shallow dish. Small well (approx 1.6cm) inside base of the foot
|
|
| 47.2.29
|
Female tambourine player, with wheelmade body, moulded face and handmade arms. Facial features well preserved. Right hand plays tambourine and is placed higher than left.
|
|
| 58.2.6
|
One-handled bowl. Rim is slightly concave. Handle is in wishbone shape. A deep well is in the centre, of a greatly smaller diameter than the rest of the bowl. For general shape cf. Sydney, Nicholson Museum 55.18 (Base-ring wheel-made Ware, Late Cypriot III).
|
|
| 60.8.3A-B
|
Lid: three tiered round knob with central, nearly conical well; short concave stem curving above and below into knob and lid; nearly flat lid tapering gently to a short vertical rim, rounded at both edges. The underside is slightly hollowed under the knob. Lekanis: shallow bowl with a short nearly vertical flange, rounded at the lip, straight but tapering walls, slightly carinated and narrowing, with convex lower portion, to a very short stem, on a rounded disk foot, with a flat resting surface, curved on the underside, with a rounded point at the centre. A wishbone handle rises from the top of the wall, on either side; a lug protrudes from either side of each handle.
Ure 1960, 216 notes that what remains of the one handle indicates that it was pointed (wish-bone shaped) at the centre as well as rounded in section.
|
|
| 61.6.1.2
|
Uneven rim; sloping sides form a conical shape; small well in bottom of interior; flat base.
|
|
| 77.5.1.1-17
|
Seventeen fragments from the same Nikosthenic amphora. 1) Should be rejoined to 2. Part of the body. There is white plaster on both surfaces . 2) Should be rejoined to 1. Part of the body. There are traces of plaster on both sides and adhesives. 3) Part of the body. White plaster and adhesives on both sides. 4) Part of the body. White plaster on both sides and adhesives. 5) Should be rejoined to 6. Part of the body. Adhesives. 6) Should be rejoined to 5. Part of the body. Exterior: There are areas that have been chipped off and few bits that have been pitted off. Interior: There is a layer of white plaster. 7) Could be rejoined to 8? Part of the body. There are bits that have been pitted off on the exterior and the interior is covered with plaster and adhesives. 8) Could be rejoined to 7? Part of the body. White plaster and adhesives on the interior and traces of plaster on the exterior, where there are also bits that have been pitted off. 9) Should be rejoined to 10. Part of the body. White plaster on both surfaces. 10) Should be rejoined to 9. Part of the body. The interior is covered with white plaster and there are traces of it on the exterior. 11) Should be rejoined to 12. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 12) Should be rejoined to 11. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 13) Should be rejoined to 14. Part of the neck. There are traces of white plaster on the interior. Many bits have been pitted off from boith surfaces. 14) Should be rejoined to 13 and 15. Part of the neck. There are traces of plaster and adhesives on both sides, as well as many bits that have been pitted off. 15) Should be rejoined to 14. Part of the neck. There are traces of white plaster on both surfaces, as well as adhesives. There are few scratches on the exterior and several bits that have been pitted off, especially from the interior. 16) Part of the body. Adhesives and traces of white plaster. There are areas on the exterior, where the colour appears to have been peeled off and some pitting off. 17) Bit of white plaster-part of rim? and covered with adhesives.
|
|
| E.62.44
|
Lid is oval with a central circular knob and traces of an incised band on top. (Lid is missing!) Body has a flat rim, same shape and size as lid so they sit together, but with a central circular opening. Thin neck leading to shoulders. Four oblong feet at each 'corner' and the base between is flat. Flat rim on top of body is reserved. The inside is a cylindrical well, not matching the contours or shape of the outside. Heavy object.
|
|
| REDMG:1935.87.24
|
Convex and large. The vessel has an incurving rim, very convex outside and well marked off from rest of bowl. The transition from bowl to and from stem to foot is an unbroken curve.
|
|
| REDMG:1935.87.29
|
Stemless. Two handles, one either side from well below the rim are bent up at the ends. Shallow body descending to a groove and then a rounded footring.
|
|
| REDMG:1951.144.1
|
Central well, surrounded by a ridge, rising to broad rim with overhanging vertical lip, tapering slightly in; on the underside the plate curves to a short, thick stem that broadens to a moulded foot, concave and flaring on the exterior surface, hollowed on the interior, with a flat resting surface, pointed at centre of plate.
|
|
| REDMG:1953.25.33
|
Central well, surrounded by a ridge and groove; walls rising to broad rim, just beyond a groove on the upper surface, with overhanging vertical lip, tapering slightly out; on the underside the plate is slightly convex and joins a short, thick, angled ring foot, with a tapering resting surface and a slightly convex, pointed underside.
|
|