| 14.9.43
|
Fragment with section of rim attached. The → walls ← thin slightly to the rim.
|
|
| 2016.5.2
|
dy. Slightly oblique handles of the stick type. Conical hollow foot with flexed → walls ←.
|
|
| 29.11.8
|
ting surface, slightly concave. A single strap handle curves arches between the → walls ← of the basket on the inside.
|
|
| 34.10.7
|
ves into an ovoid body on a tall foot ring, with slanting interior and exterior → walls ←, the latter curving to a flat resting surface, with flat underside. Two u- |
|
| 34.10.8
|
to a rounded edge, the underside of which narrows to a tapering straight sided → walls ← that would have sat inside the vase to which it belonged (perhaps a stamno |
|
| 47.10.3A-B
|
anis: slightly everted, rounded rim with flat lip, on a deep bowl with straight → walls ← in two parts, separated by a sharp carination near the bottom, attached to |
|
| 48.12.2
|
ng base (is it conical?). Two horizontal round handles are attached to the side → walls ←.
|
|
| 48.5.2
|
Mouth has thin rim and near vertical → walls ← tapering down to neck; two upside down U-shaped handles start mid-neck and |
|
| 50.10.6
|
Deep bowl; two horizontal handles emerge from just below the rim; vertical → walls ← taper down to small disk foot; concave underside with central convex circl |
|
| 50.4.13
|
Attic type skyphos (cf. Agora 12, no. 341) except for plain underside, siz |
|
| 53.8.1
|
thickened rounded lip, with a slight carination on the inside edge, with convex → walls ←, sloping down to a flat plate, at the centre of which is an omphalos (rais |
|
| 53.8.3
|
of the lekanis, on a tall, sloping ring foot, with flat resting surface, angled → walls ← on exterior and interior, and a nearly flat underside. On either side of t |
|
| 60.8.3A-B
|
with a short nearly vertical flange, rounded at the lip, straight but tapering → walls ←, slightly carinated and narrowing, with convex lower portion, to a very sh |
|
| 61.6.4
|
Deep skyphos with thickened round rim, groove just below, straight → walls ← of unusually deep body that narrows, with a sharp cuve at the bottom, to a |
|
| 61.6.5
|
with a short nearly vertical flange, rounded at the lip, straight but tapering → walls ← curving into a convex lower portion then a very short stem, on a rounded d |
|
| 80.7.1
|
of the lekanis, on a tall, sloping ring foot, with flat resting surface, angled → walls ← on exterior and interior, and a nearly flat underside. On either side of t |
|
| E.62.40
|
sits in the base. Base is wide at shoulder and tapers to the bottom with smooth → walls ←. At top is a slighlty raised rim to receive ring. Inside is a hollowed out |
|
| REDMG:1934.51.8
|
nical shallow bowl, with a slightly incurving rounded rim, slightly convex side → walls ←, and a thick, small foot, with straight sides on the exterior, tapered on |
|
| REDMG:1935.87.6
|
Rounded rim on tapered flange, below which the → walls ← spread out to a thin element that would have supported the lid; just below |
|
| REDMG:1951.145
|
p and raised edge, stepping down in three ridges, broader than the width of the → walls ←; slightly tapering → walls ← terminating in offset flanged rim.
|
|
| REDMG:1951.147.1
|
m a squat body, with a curved shoulder, flange below the shoulder, concave side → walls ← (offset at top and bottom), and a broader ring base, curved on the upper s |
|
| REDMG:1951.1714
|
Rounded, slightly everted rim on slightly concave lip, slightly convex lower → walls ← curve into a short foot, with a flat base.
|
|
| REDMG:1951.1716
|
top heavy bowl, with a slight carination in the lower third, beneath which the → walls ← become slightly concave, above a flat base; rounded interior.
|
|
| REDMG:1951.1717
|
Rounded rim on incurving lip, curves into a top heavy bowl; → walls ← become slightly concave just above the flat base; rounded interior.
|
|
| REDMG:1953.25.1
|
ridged strap handle that rejoins just above the middle of the body; convex side → walls ←; torus ring foot with slightly convex underside.
|
|
| REDMG:1953.25.26
|
wer part of the shoulder; below carination is a conical body, with concave side → walls ←, tapering down, and straightening out towards the small disk foot, flaring |
|
| REDMG:1953.25.33
|
Central well, surrounded by a ridge and groove; → walls ← rising to broad rim, just beyond a groove on the upper surface, with overh |
|
| REDMG:1953.25.40
|
Rounded rim on tapered flange, below which the → walls ← spread out to a thin element that would have supported the lid; just below |
|
| REDMG:1953.25.72
|
Round uneven rim, lopsided diagonal → walls ←, and a flat base; rough and bumpy on interior of bowl and base.
|
|
| REDMG:1953.25.73
|
Round uneven rim, slightly incurving, lopsided tapering → walls ←, convex at top and concave at bottom, and a flat base; rough and bumpy on |
|
| REDMG:1958.113.1
|
of the high shoulder, which curves continuously into the body, with convex side → walls ←, narrowing to a slightly flaring raised base, bossed on the underside.
|
|
| REDMG:1958.117.1
|
the bowl; between the handles, the bottom of the bowl is set off from the side → walls ←. A flaring, broad ring foot is convex on the interior; the underside of th |
|
| REDMG:1962.184.33.21
|
shoulder, just above a carination, from which descends the nearly straight side → walls ←; body narrow sharply at the bottom to a short stem attached to a tall moul |
|
| REDMG:1964.1631
|
Very thin → walls ←, with rounded rim, just below which are attached horizontal handles. → walls ← |
|
| REDMG:1964.1632.1
|
izontal handles are attached, and rise slightly to just above the height of the → walls ←. The sides, tapering down, are slightly convex at the top and concave belo |
|
| REDMG:1964.1676
|
Everted rim, slightly concave on the interior, concave → walls ← broadening to a carination from which the sides taper sharply to a flat ba |
|
| REDMG:1964.1714
|
Rounded, slightly everted rim on slightly concave lip, slightly convex lower → walls ← curve into a short foot, with a flat base.
|
|
| REDMG:1964.1716
|
top heavy bowl, with a slight carination in the lower third, beneath which the → walls ← become slightly concave, above a flat base; rounded interior.
|
|
| REDMG:1964.1717
|
Rounded rim on incurving lip, curves into a top heavy bowl; → walls ← become slightly concave just above the flat base; rounded interior.
|
|
| REDMG:1997.209.3
|
of the high shoulder, which curves continuously into the body, with convex side → walls ←, narrowing to a slightly flaring raised base, flat on the underside.
|
|
| REDMG:2004.97.1
|
Plain rounded rim; tapering → walls ←, slightly concave, broaden slightly at the bottom of the bowl, which is mo |
|