| 39.1.2
|
Strongly moulded rim, curving into a roughly cylindrical upper body that bulges out into the shallow bowl. Two vertical handles, roughly square in section, with horizontal pointed spurs, level with the rim, rejoin the body at the upper part of the bowl. Two-part moulded foot, with a domed underside.
|
|
| 47.10.3A-B
|
Lid: tall, conical, flat-topped knob on a sharply sloping conical lid, with plain rim, vertical profile, flat underside, leading to a short flange (0.3) to sit within lekanis.
Lekanis: slightly everted, rounded rim with flat lip, on a deep bowl with straight walls in two parts, separated by a sharp carination near the bottom, attached to a short disk foot, angled on inside and out, with a slightly convex underside. From either side of the rim extends a semicircular horizontal handle, round in section, that rises very slightly, flanked by short pointed spurs or lugs on either side of the handle.
|
|
| REDMG:1935.87.23
|
Two handles, all black and one either side which start at base of body and curl up and over, higher than mouth with small spurs at the base. Mouth has wide rim.
|
|
| REDMG:1935.87.6
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards, to which spurs are attached on either side. The lower body is offset from the handle zone, rounded in the lower part where it sharply joins a moulded foot, with groove above a spreading upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface, and a pointed, slightly offset underside.
|
|
| REDMG:1951.148
|
Broad rim with slightly convex, tapering upper surface, and overhanging concave lip; rim joins on either side with diagonal spurs at top of round columnar handles (two either side), which descend at a slight diagonal to the shoulder. Broad neck, slightly concave, attached sharply to short curving shoulder from which an ovoid body descends and tapers to the foot.
|
|
| REDMG:1953.25.39
|
Flanged rim and tapering body, to which are attached broad horizontal strap handles (rounded but almost oblong in shape), slightly canted upwards, with spurs on either side. The lower body is offset from the handle zone, rounded in the lower part where it attached to thick stem broadening to a moulded foot, with spreading upper part, slightly concave, and a broader, rounded lower part, broadening towards the base, with a conical depression on the interior, and a narrow resting surface
|
|