| 2016.5.2
|
Open rim separated from the body by a grooved band. Shallow body. Slightly oblique handles of the stick type. Conical hollow foot with flexed walls.
|
|
| 26.12.31
|
Mouth flanged and bottom of body angular. Vertical ring handles, spurred. Bottom of vase somewhat angular. Finely moulded foot, side grooved, underside concial with resting surface.
|
|
| 26.4.1A-B
|
Lid: central 'pagoda-like' knob. Pyxis: feet are grooved horizontally; raised base is slightly convex.
|
|
| 34.10.8
|
Short cylindrical knob, with grooved flat top, grooved profile, and conical stem broadening to the slightly domed top of the lid. At the midpoint of the lid, beyond a gentle groove and a ridge, the lid flares to a rounded edge, the underside of which narrows to a tapering straight sided walls that would have sat inside the vase to which it belonged (perhaps a stamnos). The underside of the lid is hollowed, rounded, and smooth.
|
|
| 37.7.4
|
Vertical ring handles, spurred, starting directly from rim. Moulded foot which is concave underneath with grooved resting surface.
|
|
| 46.9.2
|
Rim set off by ridge at level of upper attachment of handle. Lower part of body grooved in upper reserved half. Side of foot stepped, resting surface grooved. Handles spurred.
|
|
| 47.2.10
|
Rounded, thickened, out turned rim, broader than base; convex wall descending directly to a flat base, grooved on the underside.
|
|
| 50.4.17
|
Rim flat. Profile of upper half concave; moulded fillet between that and lower half. Foot is grooved and base is depressed.
|
|
| 51.4.11
|
Moulded rim, grooved, with flat upper surface and sharp lip, on a short cylindrical neck, with attaches, at a ridge, to an ovoid body, attached below, also at a ridge, to a slightly flaring stand, with splaying foot, slightly ridged on upper edge, bevelled on exterior, hollow on the interior. From the shoulder, on either side, rises an m-shaped handle (half of one chipped off) with short projections in the middle. Three holes (to enable air flow) are drilled into the upper part of the stand, just below the join.
|
|
| 55.1.1
|
Rounded outturned rim, narrowing to neck and broadening to baggy body, in a continuous curve down to the angled torus ring foot. Vertical ribbon handle, slightly grooved, loops from just below rim to the upper part of the body.
|
|
| 56.8.6
|
Rounded cup with sharply incurving rim and shallow bowl, on a short hollow stem which broadens to a disk foot with a grooved foot, and deeply concave underside.
|
|
| 59.6.1
|
Everted, concave rim, with round lip, offset by a carination from a shallow bowl, tapering sharply to a short stem that broadens to a moulded foot, concave in profile, with a nearly flat resting surface, grooved just within the resting surface, hollowed and conical within; a slightly incurving d-shaped handle rises up, on either side, from the centre of the bowl to the height of the kylix.
|
|
| 73.10.1
|
Tall knob, circular in section, flat at top except for a grooved section; knob which narrows then widens to a carination towards the bottom, and narrows again to the join with the concave lid. Flanged rim.
|
|
| REDMG:1950.25.1
|
Type 8B oinochoe. Wide mouth with rounded, slightly overhanging rim flaring out from a broad neck, attached sharply to the top of the barrel-shaped body, with a moulded ring foot, with a vertical upper part and a grooved, slightly broadening lower part; narrow, flat resting surface; slightly concave underside. Two-piece handle, knotted at the top, splays at the attachment to the rim.
|
|
| REDMG:1951.130.1
|
Oinochoe with trefoil lip. Broad neck, widening into grooved trefoil lip, from the back of which extends a vertical tripartite strap handle that reattaches at the middle of the shoulder; broad ridge at the bottom of the neck to which is attached the ovoid body, tapering to a broad ring base, convex on the exterior, with a flat resting surface.
|
|
| REDMG:1951.152
|
Moulded grooved rim, with a flat overhanging lip, atop a thin, nearly cylindrical neck, attached to an ovoid body, ridged at the top; raised base, with thin reseting surface and slightly pointed underside.
|
|
| REDMG:1953.25.30
|
White-ground lekythos, group iii. Conical mouth with flat rim, slightly offset from cylindrical neck which curves sharply into nearly diagonal shoulder; vertical strap handle (missing) reached from top of neck to bottom of the shoulder, below which a carination marks the join with the straight body that tapers down to a high, molded, pedestal foot, grooved at the top of the slightly convex vertical surface, concave on the underside, with a nipple at the centre.
|
|
| REDMG:1953.25.51
|
Upturned rim, slightly offset from the neck, which is cylindrical and nearly straight, joining an ovoid body, slightly baggy, supported by a broad ring base. Vertical strap handle, grooved, extends horizontally from the rim and curves back into the body, which it joins in the upper part.
|
|
| REDMG:1953.25.55
|
Wide flaring mouth with rounded rim; short neck narrowing to sharp join to an ovoid body that tapers sharply at the bottom to a flat base; grooved just above the base. Two-piece strap handle splays at the attachment to the rim and rejoins the shoulder (for handle cf. RM.1950.25, which is, however, knotted).
|
|
| REDMG:1953.25.57
|
Cup mouth with slighted everted, rounded rim, concave lip, narrows to neck, which flares to a top-heavy body; round vertical extends horizontally from the rim and descends in slight s-curve to the shoulder; slightly raised base with flat underside, worked with spiral pattern grooved in.
|
|
| REDMG:1953.25.61
|
Moulded mouth, flares to tall rim, which narrows to a tall, cylindrical neck; neck curves gently into a sloping shoulder, grooved near the join to the body, which broadens slightly and then tapers, with slightly concave sides, to a slightly raised base, grooved on the resting surface, flat on the sunken underside.
|
|
| REDMG:1953.25.75
|
Incurving rounded rim; interior surface curves smoothly; exterior upper part offset from a lower concave element, curving out at the bottom to flat base, marked by a ridge on the exterior; nipple surrounded by a grooved circle at centre of underside.
|
|
| REDMG:1953.25.76
|
Shallow bowl with incurved rim; raised base, with grooved resting surface.
|
|
| REDMG:1961.199.1
|
Very narrow neck, from which loops up a small, narrow strap handle, which rejoins at the middle of the broad shoulder. The shoulder curves into a bulbous body, grooved just above a slightly raised base. The underside is slightly concave at its centre. Some circular ridges (comb ot wire marks) remain on the underside.
|
|
| REDMG:1964.1632.1
|
Deep skyphos. Thin rim, slightly averted, below which u-shaped round horizontal handles are attached, and rise slightly to just above the height of the walls. The sides, tapering down, are slightly convex at the top and concave below, terminating in a groove, just above the short raised base with a flat underside, grooved on the outside.
|
|
| REDMG:1964.1648
|
Projecting rim, with rounded lip and with slightly concave mouth, from which emerges a narrow cylindrical neck, grooved at the base; sloping shoulder; narrow strap handle that curves down to the middle of the shoulder; globular body with a flat bottom.
|
|