| 47.2.10
|
Rounded, thickened, out turned rim, broader than base; convex wall descending directly to a flat base, grooved on the underside.
|
|
| E.23.41.1-25
|
Beaded necklace, not on original string, consisting of 25 beads. All are circular but some are broader, bigger, rounder than others. Two small beads, one on each end which string is tied too.
|
|
| REDMG:1935.87.6
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards, to which spurs are attached on either side. The lower body is offset from the handle zone, rounded in the lower part where it sharply joins a moulded foot, with groove above a spreading upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface, and a pointed, slightly offset underside.
|
|
| REDMG:1951.113.3
|
Rounded rim, slightly incurving, below which are attached two nearly triangular horizontal strap handles and ring base, canted slightly up; rounded body broadens slightly and then narrows to an angled ring foot, curved on the resting surface, and offset from the slightly convex underside. Body broader than standard Apulian shape, so that it can't fit easily into the sequence of Gnathian skyphoi.
|
|
| REDMG:1951.145
|
Cylindrical lid with inset flat top and raised edge, stepping down in three ridges, broader than the width of the walls; slightly tapering walls terminating in offset flanged rim.
|
|
| REDMG:1951.147.1
|
Tall cylindrical neck offset from a squat body, with a curved shoulder, flange below the shoulder, concave side walls (offset at top and bottom), and a broader ring base, curved on the upper surface, with a broad resting surface, offset, slightly concave underside. From the front of the neck extends diagonally a tubular spout, squared at the end. From the back of the spout rises a high curving strap handle, rounded on the outside, which arches in a rectangular form, and descends sharply towards the lower part of the shoulder; which bends back on itself to attach to mouth and at the back to the lower part of the shoulder. Two moulded male heads, bearded, are found on either side of the upper handle attachment.
|
|
| REDMG:1953.25.2
|
Rounded, slightly everted rim, below which are attached two horizontal handles, rounded on the outsides and slightly flattened on the insides, slightly canted and rising above the rim. Body bulges slightly below handles but otherwise tapers gradually to a thick raised base, which is slightly broader than the lowest part of the body. The underside is circumscribed with a lightly gouged band.
|
|
| REDMG:1953.25.39
|
Flanged rim and tapering body, to which are attached broad horizontal strap handles (rounded but almost oblong in shape), slightly canted upwards, with spurs on either side. The lower body is offset from the handle zone, rounded in the lower part where it attached to thick stem broadening to a moulded foot, with spreading upper part, slightly concave, and a broader, rounded lower part, broadening towards the base, with a conical depression on the interior, and a narrow resting surface
|
|
| REDMG:1953.25.40
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards. The body is rounded in the lower part and sharply joins a moulded foot, with an angled upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface.
|
|