| 2018.6.1
|
A writing tablet, with bored holes that evidence the hinge whereby it was once attached, with a cord, to a second tablet. It was once inlaid with a wax surface, within a rectangular frame, on which the writer would have scratched words with a stylus. The wax has worn away or been removed from our tablet, whereupon each side was painted white, on which ancient Greek words were written.
|
|
| 47.10.3A-B
|
Lid: tall, conical, flat-topped knob on a sharply sloping conical lid, with plain rim, vertical profile, flat underside, leading to a short flange (0.3) to sit within lekanis.
Lekanis: slightly everted, rounded rim with flat lip, on a deep bowl with straight walls in two parts, separated by a sharp carination near the bottom, attached to a short disk foot, angled on inside and out, with a slightly convex underside. From either side of the rim extends a semicircular horizontal handle, round in section, that rises very slightly, flanked by short pointed spurs or lugs on either side of the handle.
|
|
| 56.8.2
|
Tall inslanting rim with plain round lip, sharply turning to a short shoulder that broadens to an ovoid body, which tapers to a tall moulded foot, comprised of a beveled top, two concave elements, a carination, below which a scotia above a torus. The resting surface is ridged and the underside consists of a pointed convex centre, within a tapering concave part. Two u-shaped handles, round in section, rise from the bottom of the shoulder to high above the rim. On either side of each handle is a pointed lug.
|
|
| 59.6.1
|
Everted, concave rim, with round lip, offset by a carination from a shallow bowl, tapering sharply to a short stem that broadens to a moulded foot, concave in profile, with a nearly flat resting surface, grooved just within the resting surface, hollowed and conical within; a slightly incurving d-shaped handle rises up, on either side, from the centre of the bowl to the height of the kylix.
|
|
| 79.1.3
|
Circular deep body with slightly concave discus, large filling hole and a shoulder lug on the right hand side. Flat nozzle, small oval wick hole. Shallow circular foot, slightly concave with a smaller circle within the foot.
|
|
| 79.1.8
|
Small circular body with a convex shoulder and a small concave discus with an irregular filling hole at the centre. Nozzle is slightly arched and splayed at the tip with concave edges and an obtuse tip. Wick hole is oval. base is a concave small demarcated circle with a circle within.
|
|
| REDMG:1951.132.1
|
Guttus type askos: swelling rounded body with bearing at the top a large relief medallion (frontal female mask with puffed cheeks and a lock of hair knotted over the forehead) offset and raised from the body; at a distance of ca. 0.5 cm are two incised lines beyond which the body is covered with fine vertical fluting down to its midpoint. A long diagonal spout with slightly concave sides rises obliquely from the shoulder below the medallion, and terminates in a three-stepped flanged mouth. A loop handle (semicircular in cross section) rises from the shoulder at a right angle to the spout. A tall thick foot, offset from the body, with a ridge at the halfway point broadens toward a ring base, slightly rounded on the exterior, with a concave underside offset from a concave element within the narrow resting surface.
The foot is particularly tall, and is ridged in the middle: otherwise in shape this askos corresponds to Morel's type 8141h 1 (Morel 1981, pl. 209).
|
|
| REDMG:1951.160.1
|
Large krater with everted mouth and downturned rim, two recurved horizontal round handles attached to the upper part of the cylindrical body, which narrows to ashort, broad stem that curves into a pedestal foot, with a recessed band above slightly tapering sides, hollowed within.
|
|
| REDMG:1953.25.32
|
Kalathos-shaped body, with a flaring rounded rim, to the top of which are attached the looped ends of a pair of strap handles, concave on their exterior surfaces; the tubular ends of the loops rejoin the middle of each handle, and below the bottom of each handle, attached at the bottom of the cup, is a spur. Below a carination, the bottom of the cup narrows to a nearly cylindrical stem, ridged at the center, below which it widens, and smoothly curves into the top of a moulded foot, with three ridges, of increasing diameter, on the exterior surface. Within the narrow resting surface is a concave underside, with a conical hollow at centre.
|
|
| REDMG:1953.25.67
|
Nearly flat lid, with rounded rim, curving into a deep thin flange, whereby lid would have sat probably within the pyxis; button knob at centre.
|
|
| REDMG:1961.150.1
|
Spreading lip, flat, with rounded rim, above tall, cylindrical neck, with ridge at center, just above attachment of l-shaped strap-handle, joining at centre of shoulder; squat piriform body, nearly flat base, ridge at exterior, groove just within.
|
|
| REDMG:1964.1154.1
|
Outturned rounded rim , narrowing to a nearly cylindrical body (broadens slightly below) that narrows sharply to a short, nearly cylindrical stem, attached to a pedestal foot, hollow within, slightly angled on the upper surface, nearly vertical on the sides, flaring to a slighted everted base, with a rounded resting surface
|
|