| 13.10.9
|
Slightly tapered body, straight neck, elongated lip.
|
|
| 2008.7.118
|
Cylindrical tapered at both ends and pierced through the centre.
|
|
| 51.1.1
|
Flat outturned rim with rounded lip, sharply curving to nearly cylindrical bowl, slightly concave, which broadens and then tapers in the convex lower part to a disk foot, sloping on the upper part, rounded on the lower part, tapered on the interior, with flat resting surface and nearly flat underside. Just below the rim on one side are two holes for suspension.
|
|
| 51.7.2
|
Lid: slightly convex top with circular groove (1.9 cm diam.) at the centre, overhanging a cylindrical body, with straight sides, terminating in a rounded rim at bottom. Pyxis: high cylindrical body with straight sides and simple rounded rim sits atop a flanged element, with rounded edges, that slopes sharply to a foot ring with tapered interior edge and rounded resting surface.
|
|
| 68.12.3
|
Pomegranate shaped knob, with small hole in the recess at the top, smoothly attached to a short stem, slightly concave, that spreads to a short domed lid, which in turn spreads to a flat rim with sharp beveled edge, slightly thicker underside, smoothly turned to a tapered flange with a rounded edge. Hollowed, round, smooth underside.
|
|
| REDMG:1934.51.8
|
Nearly conical shallow bowl, with a slightly incurving rounded rim, slightly convex side walls, and a thick, small foot, with straight sides on the exterior, tapered on the interior; pointed underside.
For shape cf. CVA France 6 (Ensenere) pl. 22 and Lamboglia (Atti di I congr. Intrem di Studi Liguri (1950) 39, forma 26.
|
|
| REDMG:1935.87.6
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards, to which spurs are attached on either side. The lower body is offset from the handle zone, rounded in the lower part where it sharply joins a moulded foot, with groove above a spreading upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface, and a pointed, slightly offset underside.
|
|
| REDMG:1951.139.1
|
Moulded knob, topped by a slightly rounded element with inset circle and conical indentation, on upper surface; lower part of knob curves into a nearly cylindrical stem offset from a diagonal lid, with a tapered lip, with a plain rim.
|
|
| REDMG:1953.25.40
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards. The body is rounded in the lower part and sharply joins a moulded foot, with an angled upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface.
|
|
| REDMG:1953.25.68
|
Sloping lid above slightly tapered flange with a rounded rim; flat-topped knob, with sloping sides, at centre.
|
|