| 13.10.4A-B
|
Two slightly concave disks, not joined (although they sit together well). The lid is thinner than the base with no significant rim, but a beveled edge. The mirror itself has a rim on the underside, and an offset edge on the upper part. These are clearly two parts of a Hellenistic mirror with lid, typical of Hellenistic cyprus. A pair of bronze plates could be locked together because one mirror had a low cylindrical rim into which the other, with a flanged edge, could be fitted. The inside mirror is decorated on the recessed side and polished on the flat side. The outside mirror is polished on the recessed side and sometimes decorated on the flat side. The two polished sides would then lie together, sometimes plated with silver (as in the case of an example in Amathus tomb 62, published in Excavations in Cyprus). For the Greek prototypes see See A. Schwarzmaier, Griechische Klappspiegel: Untersuchungen zu Typologie und Stil (Berlin 1997).
|
|
| 52.3.4
|
Slightly convex, slanted, overhanging lip, rounded at the edge, on a slightly concave tapering rim, slightly offset from the lower bowl that curves sharply to a tall conical foot, rounded at the edge, with flat resting surface and a slightly convex underside. On either side of the rim is attached a horizontal, u-shaped ribbon handle, between a pair of lugs (handle and lugs broken off on one side).
|
|
| 53.8.3
|
Slightly convex, rounded, overhanging lip on a tall, tapering rim, a carination at the junction with the sharply sloping body or bowl of the lekanis, on a tall, sloping ring foot, with flat resting surface, angled walls on exterior and interior, and a nearly flat underside. On either side of the rim is attached a horizontal, u-shaped ribbon handle, between a pair of lugs.
|
|
| 80.7.1
|
Large lekanis with a slightly convex, rounded, overhanging lip on a tall, tapering rim, a carination at the junction with the sharply sloping body or bowl of the lekanis, on a tall, sloping ring foot, with flat resting surface, angled walls on exterior and interior, and a nearly flat underside. On either side of the rim is attached a horizontal, u-shaped ribbon handle, between a pair of lugs.
|
|
| REDMG:1953.25.32
|
Kalathos-shaped body, with a flaring rounded rim, to the top of which are attached the looped ends of a pair of strap handles, concave on their exterior surfaces; the tubular ends of the loops rejoin the middle of each handle, and below the bottom of each handle, attached at the bottom of the cup, is a spur. Below a carination, the bottom of the cup narrows to a nearly cylindrical stem, ridged at the center, below which it widens, and smoothly curves into the top of a moulded foot, with three ridges, of increasing diameter, on the exterior surface. Within the narrow resting surface is a concave underside, with a conical hollow at centre.
|
|
| REDMG:1964.1631
|
Very thin walls, with rounded rim, just below which are attached horizontal handles. Walls slightly concave, divided from a spreading, lipped torus ring foot, with a pointed resting surface, by a pair of grooves. This example corresponds to Ure's Class II.C skyphos, particularly (ii) which includes reddish-purple bands just below the level of the handles, perhaps a band at the bottom of the body where it joins the ring foot, and concentric purple bands on the underside (or plain black or reserved undersides). See Ure 1927, 24.
|
|