| 23.11.31NNNN
|
Single fragment consisting of the head and shoulders of a figure facing right. Wearing a large knobbed headdress which is decorated with tall vertical loops with a central line, over long styled hair
|
|
| 45.6.37
|
Conical mouth with a thick, slightly convex rim, merging into a short, tubular neck, from the top of which emerges a thick strap handle that loops down to the bottom of the shallow sloping shoulder; ovoid body; broad torus ring foot.
|
|
| 48.12.10
|
Long tall neck from the top of which handle loops up and then down to join edge of broad shoulder, curning slightly upwards. Straight body; sturdy, flat foot; concave base.
Cf. Smith 2003, BSA 98, p349, footnote 24, pl. 58 d-f (see also 'comments').
|
|
| 50.4.18
|
Nearly identical to a lidded mug excavated from the Pantanello Necropolis at Metaponto, published by Maria Elliott, in Carter 1998 2.643, fig. 14.2, 667 M3 (T 128-2): the Pantanello mug, which Elliott describes as an 'odd mug' and probably a local imitation of the late 5 c. Attic double handle mug (667), has a knotted handle which is otherwise similar to ours in contour and thickness. For less close comparanda cf. Morel 1981, type 5345a (citing examples from Capua and environs, e.g. CVA Capua 3, Italia 1312 no. 2: less squat, but similar); these Campanian examples are dated to ca. 300.
Convex lip with rounded outturned rim, to which is joined a vertical strap handle, tripartite, with two projections on either side of the rim attachment. The handle loops and reattaches at the top of the bulging, ribbed body (ribbing visible on the interior). Tall angled ring foot, the interior of which has an incised spiral (not visible on exterior).
|
|
| 51.7.8
|
Cup mouth with slightly concave upper surface, tubular neck offset from mouth and shoulder; ridged vertical strap handle loops up from top of neck and descends directly to the shoulder; squat body; broad torus ring foot.
|
|
| 55.1.1
|
Rounded outturned rim, narrowing to neck and broadening to baggy body, in a continuous curve down to the angled torus ring foot. Vertical ribbon handle, slightly grooved, loops from just below rim to the upper part of the body.
|
|
| REDMG:1953.25.32
|
Kalathos-shaped body, with a flaring rounded rim, to the top of which are attached the looped ends of a pair of strap handles, concave on their exterior surfaces; the tubular ends of the loops rejoin the middle of each handle, and below the bottom of each handle, attached at the bottom of the cup, is a spur. Below a carination, the bottom of the cup narrows to a nearly cylindrical stem, ridged at the center, below which it widens, and smoothly curves into the top of a moulded foot, with three ridges, of increasing diameter, on the exterior surface. Within the narrow resting surface is a concave underside, with a conical hollow at centre.
|
|
| REDMG:1961.199.1
|
Very narrow neck, from which loops up a small, narrow strap handle, which rejoins at the middle of the broad shoulder. The shoulder curves into a bulbous body, grooved just above a slightly raised base. The underside is slightly concave at its centre. Some circular ridges (comb ot wire marks) remain on the underside.
|
|