| 14.9.41
|
Fragment with rim attached. The rim is offset a little and the clay bends halfway down the fragment to lead to the base of the cup.
|
|
| 14.9.60
|
Fragment including curved outer edge, underside has distinct curved ridge halfway in. Whole piece sloped higher towards middle.
|
|
| 14.9.61
|
Small curved rim fragment. Underside has small ridge about halfway into the fragment to the inside of which the fragment has a pronounced change of angle.
|
|
| 25.4.2
|
Four-handled. Kylix style, stemmed and hollow inside stem. Handles round. At halfway points between handles are two more sets of handles but these have broken off.
|
|
| 45.6.17
|
Flared mouth with flat lip. Handle starts halfway down neck, curves up and then down to join shoulder. Long, narrow body. Broad foot. Central concave section on base.
|
|
| 70.3.3
|
Ian McPhee describes it as a Kotyle rather than Skyphos type c (?). Tapering ring base, rounded at the bottom, from which the body rises in a sharp diagonal, curving sharply approximately at the halfway point, from which it rises near vertically and eventually flares slightly to a plain, rounded rim, just below which are attached two horse-shoe shaped handles, almost round in cross section.
|
|
| REDMG:1951.132.1
|
Guttus type askos: swelling rounded body with bearing at the top a large relief medallion (frontal female mask with puffed cheeks and a lock of hair knotted over the forehead) offset and raised from the body; at a distance of ca. 0.5 cm are two incised lines beyond which the body is covered with fine vertical fluting down to its midpoint. A long diagonal spout with slightly concave sides rises obliquely from the shoulder below the medallion, and terminates in a three-stepped flanged mouth. A loop handle (semicircular in cross section) rises from the shoulder at a right angle to the spout. A tall thick foot, offset from the body, with a ridge at the halfway point broadens toward a ring base, slightly rounded on the exterior, with a concave underside offset from a concave element within the narrow resting surface.
The foot is particularly tall, and is ridged in the middle: otherwise in shape this askos corresponds to Morel's type 8141h 1 (Morel 1981, pl. 209).
|
|