| 13.10.1
|
Rat-tanged dirk (sword blade used as a dagger or spearhead), with long thin blade, pointed at both ends, with sloping shoulders. A rib runs nearly the full length of the piece (flattened in the last 2 cm of the blade end). The middle of the rib, near the attachment end, is thin, rhomboidal in section, narrowing to pointed tip or tang which is turned up slightly at the end. Approximately 1/4 down the length of the blade the flange broadens, so that two flat sides spread from the centre rib. The blade end of the dirk has nearly straight sides, but tapers gently to a rounded tip. Catling's type 1d; near Åstrom's type I4. As Catling suggests (1964, 56) the rat-tailed weapon, the most characteristic of prehistoric Cypriote metal forms, occurs in so many sizes that it is impossible to classify them as swords, dirks, daggers, or even spearheads.
|
|
| 45.6.30
|
Molded, overhanging rim with a lower flange, curving into a thin neck which gradually widens to an ovoid body; molded foot, concave on the underside.
For shape cf. bottles found at Metaponto that are similar (in shape and decoration) catalogued by L. Burn in Carter 1998, 2.632-633, especially T 192-6. Cf. also Padova, Museo Civico Archeologico inv. 1746-C: Zampieri 1996, 203-204 no. 58 (ill.).
|
|
| 47.10.3A-B
|
Lid: tall, conical, flat-topped knob on a sharply sloping conical lid, with plain rim, vertical profile, flat underside, leading to a short flange (0.3) to sit within lekanis.
Lekanis: slightly everted, rounded rim with flat lip, on a deep bowl with straight walls in two parts, separated by a sharp carination near the bottom, attached to a short disk foot, angled on inside and out, with a slightly convex underside. From either side of the rim extends a semicircular horizontal handle, round in section, that rises very slightly, flanked by short pointed spurs or lugs on either side of the handle.
|
|
| 49.12.1
|
Everted, nearly flat rim, with round lip, curves sharply to a cylindrical upper body, somewhat concave, separated from the lower body by a ridge above a flange. The lower body is comprised of four horizontal ribs, above a shallow bowl that narrows to a thin, short stem, that curves continuously into a conical foot, finishing with a broad groove above a rounded edge. The underside is hollowed. Two strap handles, which flare on either side, rise up above the rim and then descend to rejoin the body at the flange. A spur projects from the lower part of each handle, approximately in the middle of the upper body.
|
|
| 60.8.3A-B
|
Lid: three tiered round knob with central, nearly conical well; short concave stem curving above and below into knob and lid; nearly flat lid tapering gently to a short vertical rim, rounded at both edges. The underside is slightly hollowed under the knob. Lekanis: shallow bowl with a short nearly vertical flange, rounded at the lip, straight but tapering walls, slightly carinated and narrowing, with convex lower portion, to a very short stem, on a rounded disk foot, with a flat resting surface, curved on the underside, with a rounded point at the centre. A wishbone handle rises from the top of the wall, on either side; a lug protrudes from either side of each handle.
Ure 1960, 216 notes that what remains of the one handle indicates that it was pointed (wish-bone shaped) at the centre as well as rounded in section.
|
|
| 61.6.5
|
Lid: Short button knob, with flat band, beveled interior edge, and slightly convex top, curving smoothly to a nearly flat underside that smoothly joins a short, slightly concave stem, that again smoothly joins a flat, tapering smoothly to a short vertical rim, rounded at both edges. The underside is hollowed under the knob. One-handler: shallow bowl with a short nearly vertical flange, rounded at the lip, straight but tapering walls curving into a convex lower portion then a very short stem, on a rounded disk foot, with a flat resting surface, beveled on the interior, and slightly convex on the underside. A single, recurved horizontal handle, round in section, rises above the rim.
|
|
| 68.12.2
|
Short cylindrical knob, flat-topped and double-recessed in centre. The short concave stem connects the cylinder to the short domed lid, in a continuous curve. Beyond a gouge the outer 1.8 cm of the lid becomes slightly concave and after two ridges terminates in a slightly rounded edge.The underside is hollowed just below the knob, and has a short flange intended to sits inside the rim of the pyxis to which it would have belonged.
|
|
| 68.12.3
|
Pomegranate shaped knob, with small hole in the recess at the top, smoothly attached to a short stem, slightly concave, that spreads to a short domed lid, which in turn spreads to a flat rim with sharp beveled edge, slightly thicker underside, smoothly turned to a tapered flange with a rounded edge. Hollowed, round, smooth underside.
|
|
| L.2011.1.46
|
Flat circular knob, with a circular dip in the centre of the tip. In the underneath small flange.
|
|
| L.2016.3.7
|
Heavy Alabaster lid with slightly uneven rounded knob, which leads to a short stem. The stem curves into the diagonal lid with rounded rim and short, broad flange, slightly narrowing to its bottom. The underside is concave at centre.
|
|
| REDMG:1935.87.6
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards, to which spurs are attached on either side. The lower body is offset from the handle zone, rounded in the lower part where it sharply joins a moulded foot, with groove above a spreading upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface, and a pointed, slightly offset underside.
|
|
| REDMG:1951.137.1
|
Moulded knob, topped by beveled element with inset circle on upper surface; concave stem, attached to a nearly flat lid, with a moulded flange on the underside, slightly concave at centre.
|
|
| REDMG:1951.138.1
|
Moulded rounded (mushroom) knob, topped by beveled disk with inset circle, conical indentation on upper surface, surrounded by a groove; cylindrical stem offset from a to a slightly diagonal lid, with a moulded flange on the underside, concave at centre.
|
|
| REDMG:1951.147.1
|
Tall cylindrical neck offset from a squat body, with a curved shoulder, flange below the shoulder, concave side walls (offset at top and bottom), and a broader ring base, curved on the upper surface, with a broad resting surface, offset, slightly concave underside. From the front of the neck extends diagonally a tubular spout, squared at the end. From the back of the spout rises a high curving strap handle, rounded on the outside, which arches in a rectangular form, and descends sharply towards the lower part of the shoulder; which bends back on itself to attach to mouth and at the back to the lower part of the shoulder. Two moulded male heads, bearded, are found on either side of the upper handle attachment.
|
|
| REDMG:1953.25.38
|
Lekanis: slightly everted rim with diagonal flange, curves in to a shallow bowl; two flanged ribbon handles, attached horizontally just below rim; pronounced ring foot with vertical sides and raised underside. Lid: Moulded knob with deep circular depression; in centre of sloping lid, which steps down with three fasciae and then a convex lower part decorated with two incised bands; rounded rim.
|
|
| REDMG:1953.25.40
|
Rounded rim on tapered flange, below which the walls spread out to a thin element that would have supported the lid; just below this are attached two horizontal horseshoe-shaped strap handles, slightly canted upwards. The body is rounded in the lower part and sharply joins a moulded foot, with an angled upper part and a broader, rounded lower part, hollow on the interior, with a narrow resting surface.
|
|
| REDMG:1953.25.67
|
Nearly flat lid, with rounded rim, curving into a deep thin flange, whereby lid would have sat probably within the pyxis; button knob at centre.
|
|
| REDMG:1953.25.68
|
Sloping lid above slightly tapered flange with a rounded rim; flat-topped knob, with sloping sides, at centre.
|
|