| 14.9.62
|
Small ridge on underside near outer edge of fragment and slight curve along top.
|
|
| 2007.2.112
|
Fragment, slight curve to its shape.
|
|
| 2007.4.85
|
Curve of fragment suggests neck of vessel
|
|
| 2007.9.5
|
One long, straightish edge, the other edge in a convex curve, over all forming the vague shape of a semi-circle.
|
|
| 2008.7.54
|
Hexagonal fragment from possibly neck of a pot as the exterior top of the fragment curves out into what could be a lip; exterior base of fragment also begins to curve outwards; horizontal curvature to the fragment
|
|
| 22.3.7
|
Stemless. Inside, deep concave rim, sharply marked off although the outside is an unbroken curve and does not follow contours of the inside. Groove separates the body from the short foot.
|
|
| 23.4.1
|
Stemless. Groove separating slightly flaring rim from body. Handles curve slightly upwards from the top of the body. Another groove at join between body and foot.
|
|
| 25.9.3
|
The rim is wide and sloping, the handle is double, of ellipsoid cross-section and forms an intense curve against the body, which is ovaloid and inflated. The base is ring-shaped and narrower than the rest of the vessel.
|
|
| 47.2.12
|
Rounded, slightly incurved rim; shallow convex upper wall divided by a reserved groove from a sharply concave wall that runs continuously down to the foot, although only a single curve is perceived on the interior. Short torus ring foot, with a narrow reserved resting surface and a reserved medallion at the centre of the underside, circumscribed by a concentric ridge. Convex-concave profile.
|
|
| 47.2.4
|
Rheneia cup: stemless cup with riddled handles of ellipsoid cross-section that curve upwards and ring-shaped base.
|
|
| 48.5.2
|
Mouth has thin rim and near vertical walls tapering down to neck; two upside down U-shaped handles start mid-neck and curve upwards before joining the shoulder; inverted ovoid body; near conical foot with mirrored concave base.
|
|
| 49.8.3
|
Very broad, up sloping rim; two handles start near the top of the body and curve vertically upwards; tall body with vertical sides curves down uninterrupted into stem; thick, flat foot with ridge at top; conical underside.
|
|
| 49.8.7
|
Ridge between shallow bowl and outurned rim; two cylindrical handles curve upwards from just below ridge; hole in base where stem was
|
|
| 50.3.1
|
Flat rim; shallow mouth; broad neck; two handles curve upwards from near the bottom of the neck to the top of the body; small ridge between neck and shoulder; body tapers into broad, thick, flat base; underside concave.
|
|
| 50.4.10
|
Type C cup. Slightly everted rim with thickened concave lip, from below which emerge two horizontal rounded handles in an oblong shape, that curve up to just below the rim. Shallow bowl flows uninterrupted into a thick stem, which tapers out until a ridge, below which it is cylindrical; thick torus ring foot with slightly sloping upper side and conical underside.
|
|
| 50.4.13
|
Attic type skyphos (cf. Agora 12, no. 341) except for plain underside, size (somewhat smaller than Attic examples), and perhaps breadth of handles. Rounded rim, below which are two horizontal round handles, horseshoe shaped. Walls continuously curve into a deep bowl, divided from the short torus ring foot by a groove.
|
|
| 51.1.3
|
Thick, wide rim with flat top, broad neck. Two rounded handles curve upwards from the top of the body to the neck, from the middle of which they continue in a broad, vertical strap handle to the rim. The body tapers into the narrower bottom and thick, wide base.
|
|
| 52.3.1
|
Wide mouth with flat, reserved rim. Two strap handles, one on each side, curve up from top of neck then down to shoulder. Body is inverted pear shape, tapering to very small foot with groove in middle.Ring on the junction of the body and the foot. Underside almost conical up to small, central, convex circle
|
|
| 55.1.1
|
Rounded outturned rim, narrowing to neck and broadening to baggy body, in a continuous curve down to the angled torus ring foot. Vertical ribbon handle, slightly grooved, loops from just below rim to the upper part of the body.
|
|
| 56.8.3
|
Deep body tapers sharply towards foot; circular handles curve slightly upwards without reaching the height of the rim; conical footring.
|
|
| 58.2.4
|
Wide rim with bevelled lip. Long wide neck leading to a short and rounded body, base protrudes from body but has been damaged (during firing process ?). The handle attaches to the top of the body and then again at the join of the rim and the neck. There is a fork shaped spur which follows the curve of the handle and rim and then continues above the main body of the jug.
|
|
| 59.6.3
|
Single but ornate handle that has pointed oval at bottom, two moulded lines towards top and a piece that curves up separate to the main handle in a 'cobra-like' strike pose. The main piece of the handle extends along rim of vessel in a leaf-like shape with notches in the edges. Mouth is wide and has small rim. Outside body is marked with 4 pairs of incised bands around its sides. Small curve at side of foot. Base is flat but has 6 incised concentric circles and a central sunken dot.
|
|
| 68.12.2
|
Short cylindrical knob, flat-topped and double-recessed in centre. The short concave stem connects the cylinder to the short domed lid, in a continuous curve. Beyond a gouge the outer 1.8 cm of the lid becomes slightly concave and after two ridges terminates in a slightly rounded edge.The underside is hollowed just below the knob, and has a short flange intended to sits inside the rim of the pyxis to which it would have belonged.
|
|
| 73.6.3
|
Fragment from pot with multiple sides of varying shapes. Square-like in appearance, there is a slight curve on the bottom right side, and the right side itself has a chunk chipped from it.
|
|
| REDMG:1935.87.24
|
Convex and large. The vessel has an incurving rim, very convex outside and well marked off from rest of bowl. The transition from bowl to and from stem to foot is an unbroken curve.
|
|
| REDMG:1947.13.1
|
Large pseudo-panathenaic amphora with a cup-shaped mouth terminating in an outturned rim; offset neck divided from the shoulder by a plastic ring from which rise two vertical strap handles that curve down to the bottom of the sloping shoulder; ovoid body tapering to a thick stem on a pedestal base (not original).
|
|
| REDMG:1951.159.1
|
Large pseudo-panathenaic amphora with an offset neck divided from the shoulder by a plastic ring from which rise two vertical strap handles that curve down to the bottom of the sloping shoulder; ovoid body tapering to a thick stem on a pedestal base (not original).
|
|
| REDMG:1951.1714
|
Rounded, slightly everted rim on slightly concave lip, slightly convex lower walls curve into a short foot, with a flat base.
|
|
| REDMG:1953.25.15
|
Trefoil lip attached at the the back to a broad, high curved strap handle that curves in slightly to the middle of the shoulder; short cylindrical neck joining stepped shoulder in a continuous curve; globular body curves into a short ring foot with diagonal resting surface and slightly concave underside.
|
|
| REDMG:1953.25.16
|
Trefoil mouth at the back of which is attached a hook-shaped round handle that begins above the height of the mouth and turns back to join the shoulder, with a slight spur; short neck curving into a baggy body in a continuous curve; short ring foot with narrow, rounded resting surface, diagonal inside wall, and pointed underside. Handle attachment is indicative of the Dotted Spray Group
|
|
| REDMG:1953.25.54
|
Wide-mouthed mug. Rounded outturned rim, narrowing at the neck and broadening to a baggy body, in a continuous curve down to the thick torus ring foot, with a thin resting surface, diagonal element, and offset underside; a vertical loop ribbon handle is tucked in just below the rim where it adjoins the upper half of the body.
|
|
| REDMG:1958.117.1
|
Rounded, slightly incurving rim, which which rise (at slight angles) two high swung strap handles, rejoined at the bottom of the bowl in a continuous curve with the bottom of the bowl; between the handles, the bottom of the bowl is set off from the side walls. A flaring, broad ring foot is convex on the interior; the underside of the bowl is slightly convex. On the interior, the bottom of the bowl is offset from the side walls at a sharp carination.
|
|
| REDMG:1964.1663
|
Rounded, slightly raised rim; two pinched round horizontal handles, round in section, rise at a diagonal from the sloping shoulders which curve gently down to a small raised base, concave on the underside.
|
|
| REDMG:1964.1714
|
Rounded, slightly everted rim on slightly concave lip, slightly convex lower walls curve into a short foot, with a flat base.
|
|
| REDMG:2004.97.1
|
Plain rounded rim; tapering walls, slightly concave, broaden slightly at the bottom of the bowl, which is moulded with two carinations; diagonal profile to bottom of bowl; tall cylindrical stem, slightly bulging at the middle, curves out to a flat disk foot, with rounded sides, but an indeterminate bottom. Two vertical strap handles swing up from the rim and rejoin the vase at the lower carination, where they comprise a smooth curve with the bottom of the bowl.
|
|