| 34.10.8
|
Short cylindrical knob, with grooved flat top, grooved profile, and conical stem broadening to the slightly domed top of the lid. At the midpoint of the lid, beyond a gentle groove and a ridge, the lid flares to a rounded edge, the underside of which narrows to a tapering straight sided walls that would have sat inside the vase to which it belonged (perhaps a stamnos). The underside of the lid is hollowed, rounded, and smooth.
|
|
| 45.10.1
|
High, curved, thick, black handle which bends back on itself to attach to mouth and at the back to the lower part of the shoulder. At the mouth attachment are two moulded heads; spout has central channel and two ridges at moulded rim. The cylindrical neck becomes bell shaped in its lower part, and a ridge marks its attachment to the shoulder, which is slightly concave. Beyond the handle attachment is a flat rim, offset from the shoulder and, more sharply, from the body beneath it, which is upright but slightly convex. The very short ring foot, with broad resting surface, is as broad as the rim around the shoulder.
|
|
| 68.12.2
|
Short cylindrical knob, flat-topped and double-recessed in centre. The short concave stem connects the cylinder to the short domed lid, in a continuous curve. Beyond a gouge the outer 1.8 cm of the lid becomes slightly concave and after two ridges terminates in a slightly rounded edge.The underside is hollowed just below the knob, and has a short flange intended to sits inside the rim of the pyxis to which it would have belonged.
|
|
| REDMG:1951.132.1
|
Guttus type askos: swelling rounded body with bearing at the top a large relief medallion (frontal female mask with puffed cheeks and a lock of hair knotted over the forehead) offset and raised from the body; at a distance of ca. 0.5 cm are two incised lines beyond which the body is covered with fine vertical fluting down to its midpoint. A long diagonal spout with slightly concave sides rises obliquely from the shoulder below the medallion, and terminates in a three-stepped flanged mouth. A loop handle (semicircular in cross section) rises from the shoulder at a right angle to the spout. A tall thick foot, offset from the body, with a ridge at the halfway point broadens toward a ring base, slightly rounded on the exterior, with a concave underside offset from a concave element within the narrow resting surface.
The foot is particularly tall, and is ridged in the middle: otherwise in shape this askos corresponds to Morel's type 8141h 1 (Morel 1981, pl. 209).
|
|
| REDMG:1953.25.33
|
Central well, surrounded by a ridge and groove; walls rising to broad rim, just beyond a groove on the upper surface, with overhanging vertical lip, tapering slightly out; on the underside the plate is slightly convex and joins a short, thick, angled ring foot, with a tapering resting surface and a slightly convex, pointed underside.
|
|