| 2008.7.132
|
Appears to be shoulder (neck) of pot. Lug protrudes from fragment with hole piercing it horizontally.
|
|
| 23.11.31E
|
Profile figure facing left wearing a helmet and holding a shield with bike spokes formation. Appears to have once held a spear. Two prominent wide legs emerge from underneath the shield. Lead is an off-colour brown-grey.
|
|
| 23.11.31IIII
|
Female facing left, wearing a pointed headdress over long styled hair. One hand appears to be held up to the face. There is a thin spike projecting upwards at the back. The skirt is belted at the waist, and is patterned with vertical bands containing zigzags or chevrons which terminate at a shin-length curved hem. The left shin and foot appear angled back to the other foot, giving the figure the appearance of walking.
|
|
| 23.11.31MMM
|
Female wearing an elaborate pronged headdress and long skirts. The right arm appears heavier, as though draped in or carrying something.
|
|
| 26.7.11
|
There is a single strap-handle at the top. There is a small ball of clay, on the interior, which appears to plug up a hole at the top of the bell. Cf. especially Wolters-Bruns pl. 43.13
|
|
| 27.4.5
|
Rim turns sharply out, broad and flat on top. Handles rounded at far end and with upward twist. In centre of bowl a well 1.5 cm deep occupies the space interior of the stem. The foot appears in three stages, the first ridge being the narrowest, and the other two getting bigger in sequence.
|
|
| 50.5.1
|
Trefoil lipped oinochoe with rounded protrusions either side of neck-handle join. Single curved handle that reaches over into mouth, appears to have had an oblong pattern, and is flanked by moulded protrusions at the top and bottom. Wide neck with a groove at juncture with bulbous body. Ring foot reserved and base raised.
|
|
| 77.5.1.1-17
|
Seventeen fragments from the same Nikosthenic amphora. 1) Should be rejoined to 2. Part of the body. There is white plaster on both surfaces . 2) Should be rejoined to 1. Part of the body. There are traces of plaster on both sides and adhesives. 3) Part of the body. White plaster and adhesives on both sides. 4) Part of the body. White plaster on both sides and adhesives. 5) Should be rejoined to 6. Part of the body. Adhesives. 6) Should be rejoined to 5. Part of the body. Exterior: There are areas that have been chipped off and few bits that have been pitted off. Interior: There is a layer of white plaster. 7) Could be rejoined to 8? Part of the body. There are bits that have been pitted off on the exterior and the interior is covered with plaster and adhesives. 8) Could be rejoined to 7? Part of the body. White plaster and adhesives on the interior and traces of plaster on the exterior, where there are also bits that have been pitted off. 9) Should be rejoined to 10. Part of the body. White plaster on both surfaces. 10) Should be rejoined to 9. Part of the body. The interior is covered with white plaster and there are traces of it on the exterior. 11) Should be rejoined to 12. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 12) Should be rejoined to 11. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 13) Should be rejoined to 14. Part of the neck. There are traces of white plaster on the interior. Many bits have been pitted off from boith surfaces. 14) Should be rejoined to 13 and 15. Part of the neck. There are traces of plaster and adhesives on both sides, as well as many bits that have been pitted off. 15) Should be rejoined to 14. Part of the neck. There are traces of white plaster on both surfaces, as well as adhesives. There are few scratches on the exterior and several bits that have been pitted off, especially from the interior. 16) Part of the body. Adhesives and traces of white plaster. There are areas on the exterior, where the colour appears to have been peeled off and some pitting off. 17) Bit of white plaster-part of rim? and covered with adhesives.
|
|
| 79.1.14
|
large circular shape with a short rounded nozzle. Three bisected un-pierced lugs placed on the shoulder of the lamp equidistantly. The discus is sunken and there is a moulded rim to the discus which runs all the way around the wick hole in a continuous form. The wick hole and the filling hole are the same size and are in line with each other, there is also what appears to be an air hole in-between the channel of moulding. There is a ring base.
|
|
| E.62.1
|
Heavy, wide bracelet, almost circular. Naturally formed twist appears in side.
|
|
| E.62.47
|
This could be part of a pot as the top of the fragment appears to form a lip and the fragment ins curved.
|
|
| E.65.6
|
Long, thin ornament from a coffin lid: the centre appears to have a kind of knot carved into it with three ridges on either side of this.
|
|
| REDMG:1964.1615.1
|
Circular deep body, convex shoulder, small circular concave discus with reasonably large central filling hole. Small rounded nozzle with a medium sized flat, circular wick hole, at base of nozzle there appears to be a small air hole. Flat vertical handle with circular piercing through it. Handle is high above the body and reaches down towards the base. Base is circular and flat, it is delineated by two moulded bands.
|
|
| TEMP.2005.1.5
|
Neck and top section of the body. Top appears to have squared area; perhaps where a handle was connected.
|
|