| 51.4.11
|
Moulded rim, grooved, with flat upper surface and sharp lip, on a short cylindrical neck, with attaches, at a ridge, to an ovoid body, attached below, also at a ridge, to a slightly flaring stand, with splaying foot, slightly ridged on upper edge, bevelled on exterior, hollow on the interior. From the shoulder, on either side, rises an m-shaped handle (half of one chipped off) with short projections in the middle. Three holes (to enable air flow) are drilled into the upper part of the stand, just below the join.
|
|
| 78.12.9
|
Large, deep, circular body, small convex shoulder, concave discus with a small filling hole at the center. Medium flat nozzle (broken) concave sides with a small air hole at the base of the nozzle, the start of a rounded tip with a circular wick hole. Space for handle. Circular flat delineated base.
|
|
| 79.1.14
|
large circular shape with a short rounded nozzle. Three bisected un-pierced lugs placed on the shoulder of the lamp equidistantly. The discus is sunken and there is a moulded rim to the discus which runs all the way around the wick hole in a continuous form. The wick hole and the filling hole are the same size and are in line with each other, there is also what appears to be an air hole in-between the channel of moulding. There is a ring base.
|
|
| REDMG:1964.1615.1
|
Circular deep body, convex shoulder, small circular concave discus with reasonably large central filling hole. Small rounded nozzle with a medium sized flat, circular wick hole, at base of nozzle there appears to be a small air hole. Flat vertical handle with circular piercing through it. Handle is high above the body and reaches down towards the base. Base is circular and flat, it is delineated by two moulded bands.
|
|