2008.7.41
|
Rim fragment with 4 broken edges; Exterior: LH side has a ridge toward base of fragment
|
|
34.10.11
|
Rounded body narrowing toward base. Small round handle. Spout protruding from the top. Lid with round knob handle.
|
|
REDMG:1951.132.1
|
Guttus type askos: swelling rounded body with bearing at the top a large relief medallion (frontal female mask with puffed cheeks and a lock of hair knotted over the forehead) offset and raised from the body; at a distance of ca. 0.5 cm are two incised lines beyond which the body is covered with fine vertical fluting down to its midpoint. A long diagonal spout with slightly concave sides rises obliquely from the shoulder below the medallion, and terminates in a three-stepped flanged mouth. A loop handle (semicircular in cross section) rises from the shoulder at a right angle to the spout. A tall thick foot, offset from the body, with a ridge at the halfway point broadens toward a ring base, slightly rounded on the exterior, with a concave underside offset from a concave element within the narrow resting surface.
The foot is particularly tall, and is ridged in the middle: otherwise in shape this askos corresponds to Morel's type 8141h 1 (Morel 1981, pl. 209).
|
|
REDMG:1951.151.1
|
According to Trendall and Cambitoglou, RFVA 1.278.149, this is a special lekythos shape. Cup mouth, slightly flaring at the top, with a broad rim, convex on the upper surface; the mouth is offset from a short cylindrical neck that broadens toward the bulbous squat body; short ring base, rounded in profile, with narrow, flat resting surface and recessed underside; strap handle rises from the upper part of the shoulder, along the side of the neck and curves to rejoins at the lowest part of the shoulder.
|
|
REDMG:1951.157.1
|
Cup mouth, flaring at the top, with a broad rim, convex on the upper surface; the mouth is offset from a short cylindrical neck that broadens toward the squat, high shouldered body, from which it is offset; tall but narrow ring base with rounded resting surface and slightly convex underside; strap handle rises from the side of the neck and rejoins at the lowest part of the shoulder.
|
|
REDMG:1953.25.35
|
Chimney mouth, bell-shaped, flaring at the top, with a broad rim, convex on the upper surface, and sloping in; the mouth is offset from a short neck that broadens toward the barrel-shaped body, from which it is also offset; thick disk foot, rounded in profile, with a thin resting surface, concave on the underside, pointed at centre; strap handle (missing) rose from the side of the neck and rejoined at the lowest part of the shoulder.
|
|