2006.12.112
|
Fragment of base or stand of vessel, with handle attached
|
|
2008.7.49
|
Small base fragment broken on 5 sides with part of the stand broken on one side
|
|
34.8.15A
|
Doughnut shaped ring stand with hole in the middle for small vase (34.8.15B)to rest on.
|
|
34.8.15B
|
Squat neck with lip, round in body, round bottom (sits on stand 34.8.15A).
|
|
51.4.11
|
Moulded rim, grooved, with flat upper surface and sharp lip, on a short cylindrical neck, with attaches, at a ridge, to an ovoid body, attached below, also at a ridge, to a slightly flaring stand, with splaying foot, slightly ridged on upper edge, bevelled on exterior, hollow on the interior. From the shoulder, on either side, rises an m-shaped handle (half of one chipped off) with short projections in the middle. Three holes (to enable air flow) are drilled into the upper part of the stand, just below the join.
|
|
56.8.8
|
The body is conical, widening towards the top. The rim has horizontal sides and a small lip at the top. The band handles are almost ellipsoid, with peaked terminations. Ribbon handles. The base is in the shape of an inverted echinus (a conical stand?).
|
|
REDMG:1935.87.32
|
Column krater. The handles have two bars of a cylindrical cross-section and adjoin in a square at the rim, having side-surfaces above the bars. The foot is in the shape of an inverted echinus, a cylindrical stand widening towards the bottom. There is also a plastic ring just below the lowest part of the body.
|
|