13.10.14
|
Flat rectangular votive plaque (top slightly rounded) with naked figure in relief.
|
|
14.9.2
|
Fat body, long bottle neck with spreading lip, large U-shaped handle. Two moulded rings round neck at junction with handle. Foot conical. Cf. Sydney, Nicholson 52.418 (with shorter foot and more relief decoration)
|
|
2005.9.5
|
Cast of a low relief wall panel from Deir el Bahari. Copies relief.
|
|
2005.9.6
|
Cast of a low relief from an Egyptian wall. Copies a panel.
|
|
29.6.1
|
Plaster cast of a three-sided sculptural relief
|
|
34.10.27
|
Standing male figure in a cloak with his legs crossed, leaning on a support to his right. Figurine is hollow and has large hole in the back. No relief sculpture on the reverse side.
|
|
53.8.1
|
Mesomphalos phiale with a thickened rounded lip, with a slight carination on the inside edge, with convex walls, sloping down to a flat plate, at the centre of which is an omphalos (raised central boss), decorated in relief all around.
|
|
69.7.1
|
Foot-shaped aryballos; Dohan Morrow's Group II, 'network sandals' (Dohan Morrow 1985, 6-9) or Ducat's type B foot-shaped vases (Ducat 1966, 182-84).
Foot-shaped aryballos with a broad rim, short vertical strap handle, squared, offset neck; the body of the vase in the shape of a left foot, including ankle, with relief decoration that gives the effect of a sandal enclosing it, and a flat, reserved base.
|
|
71.6.1
|
Rectangular element with two protrusions to the side, from the lower part, and a molded satyr face in relief, which serves as a lug.
|
|
REDMG:1951.132.1
|
Guttus type askos: swelling rounded body with bearing at the top a large relief medallion (frontal female mask with puffed cheeks and a lock of hair knotted over the forehead) offset and raised from the body; at a distance of ca. 0.5 cm are two incised lines beyond which the body is covered with fine vertical fluting down to its midpoint. A long diagonal spout with slightly concave sides rises obliquely from the shoulder below the medallion, and terminates in a three-stepped flanged mouth. A loop handle (semicircular in cross section) rises from the shoulder at a right angle to the spout. A tall thick foot, offset from the body, with a ridge at the halfway point broadens toward a ring base, slightly rounded on the exterior, with a concave underside offset from a concave element within the narrow resting surface.
The foot is particularly tall, and is ridged in the middle: otherwise in shape this askos corresponds to Morel's type 8141h 1 (Morel 1981, pl. 209).
|
|