| 13.10.4A-B
|
Two slightly concave disks, not joined (although they sit together well). The lid is thinner than the base with no significant rim, but a beveled edge. The mirror itself has a rim on the underside, and an offset edge on the upper part. These are clearly two parts of a Hellenistic mirror with lid, typical of Hellenistic cyprus. A pair of bronze plates could be locked together because one mirror had a low cylindrical rim into which the other, with a flanged edge, could be fitted. The inside mirror is decorated on the recessed side and polished on the flat side. The outside mirror is polished on the recessed side and sometimes decorated on the flat side. The two polished sides would then lie together, sometimes plated with silver (as in the case of an example in Amathus tomb 62, published in Excavations in Cyprus). For the Greek prototypes see See A. Schwarzmaier, Griechische Klappspiegel: Untersuchungen zu Typologie und Stil (Berlin 1997).
|
|
| 22.9.1
|
Pappas figurine consisting of a rectangular body, ovoid in cross-section, flaring at the base, with a concave resting surface. At the top of the body or trunk, two rudimentary 'arms' extend in triangular forms that terminate in rounded stumps; above, the neck rises in a cylinder from which (on the front) extends a protrusion that suggests a nose, above which is a flat piece of clay coiled back on itself, resting against a widening cylindrical 'polos' crown, which is concave at the top.
|
|
| 45.10.1
|
High, curved, thick, black handle which bends back on itself to attach to mouth and at the back to the lower part of the shoulder. At the mouth attachment are two moulded heads; spout has central channel and two ridges at moulded rim. The cylindrical neck becomes bell shaped in its lower part, and a ridge marks its attachment to the shoulder, which is slightly concave. Beyond the handle attachment is a flat rim, offset from the shoulder and, more sharply, from the body beneath it, which is upright but slightly convex. The very short ring foot, with broad resting surface, is as broad as the rim around the shoulder.
|
|
| 71.12.5
|
Long, thin strigil steeply curved. The handle is thicker at the front and thinner at the back where it bends over to form an oblong. The thinner piece is not attached to the body but curves back on itself and end is a flat circle.
|
|
| 73.6.3
|
Fragment from pot with multiple sides of varying shapes. Square-like in appearance, there is a slight curve on the bottom right side, and the right side itself has a chunk chipped from it.
|
|
| REDMG:1951.147.1
|
Tall cylindrical neck offset from a squat body, with a curved shoulder, flange below the shoulder, concave side walls (offset at top and bottom), and a broader ring base, curved on the upper surface, with a broad resting surface, offset, slightly concave underside. From the front of the neck extends diagonally a tubular spout, squared at the end. From the back of the spout rises a high curving strap handle, rounded on the outside, which arches in a rectangular form, and descends sharply towards the lower part of the shoulder; which bends back on itself to attach to mouth and at the back to the lower part of the shoulder. Two moulded male heads, bearded, are found on either side of the upper handle attachment.
|
|