| 13.10.1
|
Rat-tanged dirk (sword blade used as a dagger or spearhead), with long thin blade, pointed at both ends, with sloping shoulders. A rib runs nearly the full length of the piece (flattened in the last 2 cm of the blade end). The middle of the rib, near the attachment end, is thin, rhomboidal in section, narrowing to pointed tip or tang which is turned up slightly at the end. Approximately 1/4 down the length of the blade the flange broadens, so that two flat sides spread from the centre rib. The blade end of the dirk has nearly straight sides, but tapers gently to a rounded tip. Catling's type 1d; near Åstrom's type I4. As Catling suggests (1964, 56) the rat-tailed weapon, the most characteristic of prehistoric Cypriote metal forms, occurs in so many sizes that it is impossible to classify them as swords, dirks, daggers, or even spearheads.
|
|
| 13.10.24
|
Cylindrical alabastron, with rounded base, tapering at both ends, more sharply to the mouth; the shape, dimensions, and proportions are comparable to that of Ure 13.10.23, which is, however, complete.
|
|
| 13.10.5
|
Hexagonal fragment perhaps broken at both ends. Dagger with angular shoulder and straight butt; ogival outline, lower end flattened.
|
|
| 2006.12.27
|
Cylindrical. Tapers outward at both ends, with two wider ridges at once end
|
|
| 2007.9.4
|
Both long edges are curved, one more greatly so, resulting in the width of fragment being much wider at one end, meetimg the horizontal edge at a small point.
|
|
| 2008.7.118
|
Cylindrical tapered at both ends and pierced through the centre.
|
|
| 23.11.31KK
|
Male facing left, playing pipes. Wearing only a short cloak, which is wound about the shoulders and draped to fall forward over both arms. The left hand holds the pipes to the lips, and the right hand is clenched to grip an incomplete object.
|
|
| 29.5.5
|
Handles move straight out horizontal to the body and both have small horns either side.
|
|
| 34.2.2
|
Small hydria with plain everted rim, with a round lip, curving continuously to a narrow concave neck and a sloping shoulder, then an ovoid body attached to a short disk foot, tapering on both exterior and interior, with a flat resting surface and a pointed underside. The vertical strap handle, slightly concave on its outer side, reaches from the lip to the widest part of the body, where it curves into the shoulder. Two horizontal d-shaped, upcurving handles, round in section, also rise up from the join of the shoulder and body.
|
|
| 37.11.4
|
Type B, formerly called 'glaux'. One horizontal handle and one vertical, both circular. Handles are attached just below rim which curves inwards.
|
|
| 45.6.34
|
Bell-shaped mouth tapering to a short neck that broadens to an ovoid body. High swung strap handle joins from neck to shoulder. Conical foot. 'Pagenstecher lekythos' type. Cf. CVA Michigan 1, pl. 27.11 (smaller but similar shape and surface, said to have been found at Taranto) and Lentini inv. 61597: Lagona 1973, no. 85, pl. 11 (more slender). Both of these examples have smaller handles. For Sicilian vessels of this shape (decorated with bands or undecorated) see examples from Selinunte (Anne Kustermann Graf, Selinunte. Necropoli di Manicalunga. Le tombe della Contrada Gaggera [2002] 181 inv. nos. 113/0 952 and 953, pl. 57 [tomb 113]); Camarina (MonAnt 54 [1990] 25, pl. VIII [tomb 590.2]; 54, pl. XXVI [tomb 799.1-2]; and pl. LXXXIII [tombs 1222.5-6 and 1232.2, which are taken to be (imitative of) Corinthian lekythoi).
|
|
| 50.12.51
|
Fragment almost cylindrical, but pointed at both ends.
|
|
| 59.2.2-3
|
Two white stone (possibly steatite) scarabs in a small glass specimen jar with cork top. Both examples have incised beetle features including clypeus and legs. Undersides both engraved with hieroglyphs and have longitudinal holes for threading.
|
|
| 60.8.3A-B
|
Lid: three tiered round knob with central, nearly conical well; short concave stem curving above and below into knob and lid; nearly flat lid tapering gently to a short vertical rim, rounded at both edges. The underside is slightly hollowed under the knob. Lekanis: shallow bowl with a short nearly vertical flange, rounded at the lip, straight but tapering walls, slightly carinated and narrowing, with convex lower portion, to a very short stem, on a rounded disk foot, with a flat resting surface, curved on the underside, with a rounded point at the centre. A wishbone handle rises from the top of the wall, on either side; a lug protrudes from either side of each handle.
Ure 1960, 216 notes that what remains of the one handle indicates that it was pointed (wish-bone shaped) at the centre as well as rounded in section.
|
|
| 61.6.5
|
Lid: Short button knob, with flat band, beveled interior edge, and slightly convex top, curving smoothly to a nearly flat underside that smoothly joins a short, slightly concave stem, that again smoothly joins a flat, tapering smoothly to a short vertical rim, rounded at both edges. The underside is hollowed under the knob. One-handler: shallow bowl with a short nearly vertical flange, rounded at the lip, straight but tapering walls curving into a convex lower portion then a very short stem, on a rounded disk foot, with a flat resting surface, beveled on the interior, and slightly convex on the underside. A single, recurved horizontal handle, round in section, rises above the rim.
|
|
| 77.5.1.1-17
|
Seventeen fragments from the same Nikosthenic amphora. 1) Should be rejoined to 2. Part of the body. There is white plaster on both surfaces . 2) Should be rejoined to 1. Part of the body. There are traces of plaster on both sides and adhesives. 3) Part of the body. White plaster and adhesives on both sides. 4) Part of the body. White plaster on both sides and adhesives. 5) Should be rejoined to 6. Part of the body. Adhesives. 6) Should be rejoined to 5. Part of the body. Exterior: There are areas that have been chipped off and few bits that have been pitted off. Interior: There is a layer of white plaster. 7) Could be rejoined to 8? Part of the body. There are bits that have been pitted off on the exterior and the interior is covered with plaster and adhesives. 8) Could be rejoined to 7? Part of the body. White plaster and adhesives on the interior and traces of plaster on the exterior, where there are also bits that have been pitted off. 9) Should be rejoined to 10. Part of the body. White plaster on both surfaces. 10) Should be rejoined to 9. Part of the body. The interior is covered with white plaster and there are traces of it on the exterior. 11) Should be rejoined to 12. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 12) Should be rejoined to 11. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 13) Should be rejoined to 14. Part of the neck. There are traces of white plaster on the interior. Many bits have been pitted off from boith surfaces. 14) Should be rejoined to 13 and 15. Part of the neck. There are traces of plaster and adhesives on both sides, as well as many bits that have been pitted off. 15) Should be rejoined to 14. Part of the neck. There are traces of white plaster on both surfaces, as well as adhesives. There are few scratches on the exterior and several bits that have been pitted off, especially from the interior. 16) Part of the body. Adhesives and traces of white plaster. There are areas on the exterior, where the colour appears to have been peeled off and some pitting off. 17) Bit of white plaster-part of rim? and covered with adhesives.
|
|
| 83.9.3
|
Bowl with outturned rim: cf. Reading 47.2.8 (from Tamassos) and Reading 83.9.4 and 83.9.7 (both from Al Mina).
|
|
| 83.9.4
|
Bowl with outturned rim: cf. Reading 47.2.8 (from Tamassos) and Reading 83.9.3 and 83.9.7 (both from Al Mina).
|
|
| 83.9.7
|
Bowl with outturned rim: cf. Reading 47.2.8 (from Tamassos) and Reading 83.9.3 and 83.9.4 (both from Al Mina).
|
|
| E.62.46
|
Flat and thin blade with a nail through to both sides, perhaps for attaching a wooden handle. The blade is pointed at one end then widens in a triangle then thins again but not to a point.
|
|
| L.2016.3.31
|
Ceramic figure of a camel, with raised head and straight posture. He is slightly craning his straightened head upwards, so that his broad neck is a little bent backwards. His eyes appear to be triangular but the iris is round. The mouth is slightly open. The saddle is just schematically depicted with a broad band surrounding the humps, both slightly tapering; the back hump is bent to the left, the front hump to the right. The tail leads down closed to his left leg. His legs are long and thin. There is a hole at the bottom of his rounded belly.
|
|
| REDMG:1953.25.77
|
Large circular, deep body, flat shoulder, slightly raised, concave discus with a small filling hole in the centre. the beginnings of two nozzles, both sided are concave with large decorative features protruding from either side. Base of handle remains with half of the hole left. Ring base, slightly concave.
|
|