| 2005.2.5
|
Rectangular prism, taller than wide, pierced through the upper part, ca. 1 cm. from the top.
|
|
| 35.5.27-29
|
Fragments, 1 consisting of seven pieces joined, 2 of two, 3 of three, probably all from one cup.
|
|
| 45.6.34
|
Bell-shaped mouth tapering to a short neck that broadens to an ovoid body. High swung strap handle joins from neck to shoulder. Conical foot. 'Pagenstecher lekythos' type. Cf. CVA Michigan 1, pl. 27.11 (smaller but similar shape and surface, said to have been found at Taranto) and Lentini inv. 61597: Lagona 1973, no. 85, pl. 11 (more slender). Both of these examples have smaller handles. For Sicilian vessels of this shape (decorated with bands or undecorated) see examples from Selinunte (Anne Kustermann Graf, Selinunte. Necropoli di Manicalunga. Le tombe della Contrada Gaggera [2002] 181 inv. nos. 113/0 952 and 953, pl. 57 [tomb 113]); Camarina (MonAnt 54 [1990] 25, pl. VIII [tomb 590.2]; 54, pl. XXVI [tomb 799.1-2]; and pl. LXXXIII [tombs 1222.5-6 and 1232.2, which are taken to be (imitative of) Corinthian lekythoi).
|
|
| 56.8.4
|
Shape 1; trefoil-lip joining at the back to a high curving vertical strap handle, which joins at the shoulder; ring base.
|
|
| 77.5.1.1-17
|
Seventeen fragments from the same Nikosthenic amphora. 1) Should be rejoined to 2. Part of the body. There is white plaster on both surfaces . 2) Should be rejoined to 1. Part of the body. There are traces of plaster on both sides and adhesives. 3) Part of the body. White plaster and adhesives on both sides. 4) Part of the body. White plaster on both sides and adhesives. 5) Should be rejoined to 6. Part of the body. Adhesives. 6) Should be rejoined to 5. Part of the body. Exterior: There are areas that have been chipped off and few bits that have been pitted off. Interior: There is a layer of white plaster. 7) Could be rejoined to 8? Part of the body. There are bits that have been pitted off on the exterior and the interior is covered with plaster and adhesives. 8) Could be rejoined to 7? Part of the body. White plaster and adhesives on the interior and traces of plaster on the exterior, where there are also bits that have been pitted off. 9) Should be rejoined to 10. Part of the body. White plaster on both surfaces. 10) Should be rejoined to 9. Part of the body. The interior is covered with white plaster and there are traces of it on the exterior. 11) Should be rejoined to 12. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 12) Should be rejoined to 11. Part of the body. The interior is covered with plaster and adhesives, while there are traces of plaster on the exterior, too. 13) Should be rejoined to 14. Part of the neck. There are traces of white plaster on the interior. Many bits have been pitted off from boith surfaces. 14) Should be rejoined to 13 and 15. Part of the neck. There are traces of plaster and adhesives on both sides, as well as many bits that have been pitted off. 15) Should be rejoined to 14. Part of the neck. There are traces of white plaster on both surfaces, as well as adhesives. There are few scratches on the exterior and several bits that have been pitted off, especially from the interior. 16) Part of the body. Adhesives and traces of white plaster. There are areas on the exterior, where the colour appears to have been peeled off and some pitting off. 17) Bit of white plaster-part of rim? and covered with adhesives.
|
|
| E.23.64
|
64 beads and 1 small faience fragment in small pill box. 60 small carnelian beads; 3 faience and 1 clear possibly quartz beads
|
|
| REDMG:1951.132.1
|
Guttus type askos: swelling rounded body with bearing at the top a large relief medallion (frontal female mask with puffed cheeks and a lock of hair knotted over the forehead) offset and raised from the body; at a distance of ca. 0.5 cm are two incised lines beyond which the body is covered with fine vertical fluting down to its midpoint. A long diagonal spout with slightly concave sides rises obliquely from the shoulder below the medallion, and terminates in a three-stepped flanged mouth. A loop handle (semicircular in cross section) rises from the shoulder at a right angle to the spout. A tall thick foot, offset from the body, with a ridge at the halfway point broadens toward a ring base, slightly rounded on the exterior, with a concave underside offset from a concave element within the narrow resting surface.
The foot is particularly tall, and is ridged in the middle: otherwise in shape this askos corresponds to Morel's type 8141h 1 (Morel 1981, pl. 209).
|
|
| REDMG:1964.1705.1
|
Cf. CVA Michigan 1, pl. 5.13
|
|